User's Manual Part 1

STAREX-IS BSM Manual
Page:132(877)
Issue:1.
0
SMD-011-PMA210
4. BSM Command
4.1. User Interface Command
4.1.1. User Management Command
4.1.1.1. System Log-in
In order to manage the system and perform the desired work, one has to log in to the
BSM system. Login can be achieved through ID and passwords given to each individual
user. In order to log in to BSM, INTERM should be performed. At this time, one has to
input ID in LOGIN on the window that is shown and put passwords in “PASSWD”. Once
the existing ID and the Passwords are input, it is changed to the state that can input
the command.
If one does not log in for a while or time expires, INTERM should be performed again.
 Input the corresponding user ID in Command “LOGIN:”
 Input the corresponding password in “PASSWORD:”.
Fig. 4.1-1 BSM System Login Window
4.1.1.2. LOG-OUT
When terminating the work in the BSM and then wanting to log in again as other ID, the
user has to log out of his/her ID first. Once he/she logs out of the system and does not
relog in, he/she cannot use the command any more.
After logout, the window for the command input disappears and it is not shown until
relog-in is done.
 Command : LOG-OUT