OWNER’S MANUAL LED LCD TV / LCD TV Please read this manual carefully before operating your set and retain it for future reference. 32LG710H 37LG710H 42LG710H 32LD650H 37LD650H 42LD650H 47LD650H 55LD650H 32LD655H 37LD655H 42LD655H P/NO : SAC34134301 (1107-REV05) 32LD660H 37LD660H 42LD660H 32LD665H 37LD665H 42LD665H 32LV555H 37LV555H 42LV555H 47LV555H 55LV555H www.lg.
WARNING / CAUTION WARNING / CAUTION WARNING RISK OF ELECTRIC SHOCK DO NOT OPEN TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
SAFETY INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS Read these instructions. Keep these instructions. Heed all warnings. Follow all instructions. 1 Do not use this apparatus near water. 2 Clean only with a dry cloth. 3 Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. 4 Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers)that produce heat.
14 15 16 4 CAUTION concerning the Power Cord : It is recommend that appliances be placed upon a dedicated circuit; that is, a single outlet circuit which powers only that appliance and has no additional outlets or branch circuits. Check the specification page of this owner's manual to be certain. Do not connect too many appliances to the same AC power outlet as this could result in fire or electric shock. Do not overload wall outlets.
22 ANTENNAS Outdoor antenna grounding If an outdoor antenna is installed, follow the precautions below. An outdoor antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can come in contact with such power lines or circuits as death or serious injury can occur. Be sure the antenna system is grounded so as to provide some protection against voltage surges and built-up static charges.
CONTENTS WARNING / CAUTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . 3 FEATURES OF THIS TV . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 PREPARATION Accessories . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Front Panel Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 Back Panel Information . . . . . . . . .
TIME SETTING Clock Setting - Auto Clock Setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 91 - Manual Clock Setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 92 Auto On/Off Time Setting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 93 Sleep Timer Setting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 94 Auto Shut-Off Setting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
FEATURES OF THIS TV ■ This feature is not available for all models. High-definition television. High-resolution digital television broadcast and playback system composed of roughly a million or more pixels, 16:9 aspect-ratio screens, and AC3 digital audio. A subset of digital television, HDTV formats include 1080i and 720p resolutions. Unlike other sensors which can only sense brightness of ambient light, LG’s “Intelligent Sensor” uses 4,096 sensing steps to evaluate its surroundings.
PREPARATION ACCESSORIES (For 32/37/42LG710H, 32/37/42/47/55LD650H, 32/37/42LD655H) (For 32/37/42/47/55LV555H) TV PO E ER ID W GU B ST D VD R i VC FO IN L RTA PO TU RE R TE EN PREPARATION Ensure that the following accessories are included with your TV. If an accessory is missing, please contact the dealer where you purchased the TV. The accessories included may differ from the images below. RN U N ME IN L T PU VO UM A/N PH AL CC MUT P H C VE MO RE E .
PREPARATION F or 32/37/42/47/55LD650H, 32/37/42LD655H, 32/37/42LD660H, 32/37/42LD665H PREPARATION x8 x2 (M4 x 20) Screws for stand assembly (Refer to P.20) Power cord Torx plus Star-head screw (Refer to P.20) Protection Cover (Refer to P.20) Protective bracket and screw for power cord (Refer to P.24) (For 32/37/42LD650H, 32/37/42LD655H, 32/37/42LD660H, 32/37/42LD665H) x4 Plug-in type holder (Refer to P.24) Cable holder (Refer to P.24) Rubbers for stand fixing (Refer to P.
F or 32/37/42/47/55LV555H PREPARATION (For 47/55LV555H) x8 (M4 x 12) Composite gender cable Screws for stand assembly (Refer to P.22) (For 32/37/42LV555H) x4 (M4 x 14) x4 x2 (M4 x 20) Screws for stand assembly (Refer to P.21) x2 Screw for stand fixing (Refer to P.27) x2 Screws for stand fixing (Refer to P.27) x4 x2 Washers for stand fixing (Refer to P.27) Nuts for stand fixing (Refer to P.27) Rubbers for stand fixing (Refer to P.
PREPARATION FRONT PANEL INFORMATION ■ Image shown may differ from your TV. PREPARATION 32/37/42LG710H CH Intelligent Sensor Adjusts picture according to the surrounding conditions. VOL CHANNEL( Buttons , VOLUME (+, -) Buttons ENTER ENTER Button MENU MENU Button Power/Standby Indicator Illuminates red in standby mode. Illuminates blue when the set is switched on.
CH VOL CHANNEL( Buttons PREPARATION 32/37/42/47/55LD650H, 32/37/42LD655H, 32/37/42LD660H, 32/37/42LD665H , ) VOLUME (+, -) Buttons ENTER SPEAKER ENTER Button MENU MENU Button INPUT Power/Standby Indicator Illuminates red in standby mode. Illuminates blue when the set is switched on. Remote Control Sensor INPUT Button POWER Button Intelligent Sensor Adjusts picture according to the surrounding conditions.
PREPARATION PREPARATION 32/37/42/47/55LV555H Power/Standby Indicator Illuminates red in standby mode. Illuminates blue when the set is switched on. Remote Control Sensor Intelligent Sensor Adjusts picture according to the surrounding conditions.
BACK PANEL INFORMATION ■ Image shown may differ from your TV. 14 6 USB IN M.P.I.
PREPARATION M.P.I.
32/37/42/47/55LV555H LAN 1 SPEAKER OUT (8 ) 18 6 SERVICE ONLY GAME CONTROL / MPI HDMI/DVI IN LAN 2 OPTICAL DIGITAL VIDEO / MONO AUDIO AV IN 1 TV-LINK CFG ANTENNA IN 11 AUDIO OUT INTERFACE 13 AUDIO IN (RGB/DVI) RGB IN (PC) 2 R COMPONENT IN L RJP 1 11 14 UPDATE 1 USB IN USB IN RESET 8 HDMI/DVI IN 2 9 5 4 AV IN 2 1 VIDEO / AUDIO 17 16 PREPARATION 15 12 RS-232C IN (SERVICE ONLY) 7 17
PREPARATION 1 PREPARATION 2 RGB IN (PC) Analog PC Connection. Uses a D-sub 15 pin cable (VGA cable). AUDIO IN (RGB/DVI) 1/8” headphone jack for analog PC audio input. 3 LAN (SERVICE ONLY) For connecting to a control network. 4 RESET Performs a hardware reset. UPDATE Enables/disables software downloads and debug mode. 5 6 18 HDMI/DVI IN Digital Connection. Supports HD video and Digital audio.
STAND INSTRUCTIONS ■ Image shown may differ from your TV. 32/37/42LG710H DETACHMENT 1 Carefully place the TV screen side down on a cushioned surface to protect the screen from damage. 2 Assemble the parts of the S TAND BODY with the STAND BASE of the TV. 1 Carefully place the TV screen side down on a cushioned surface to protect the screen from damage. 2 Remove the four screws that hold the base on. 3 Detach the stand from the TV.
PREPARATION 32/37/42/47/55LD650H, 32/37/42LD655H, 32/37/42LD660H, 32/37/42LD665H PREPARATION INSTALLATION DETACHMENT Carefully place the TV screen side down on a cushioned surface to protect the screen from damage. 1 1 Carefully place the TV screen side down on a cushioned surface to protect the screen from damage. AC IN CABLE MANAGEMENT AC IN CABLE MANAGEMENT Assemble the parts of the S TAND BODY with the STAND BASE of the TV. 2 2 STAND BODY Remove the screws that hold the stand on.
32/37/42LV555H INSTALLATION DETACHMENT 1 Carefully place the TV screen side down on a cushioned surface to protect the screen from damage. AC IN CABLE MANAGEMENT PREPARATION Carefully place the TV screen side down on a cushioned surface to protect the screen from damage. 1 AC IN CABLE MANAGEMENT Assemble the parts of the S TAND BODY with the STAND BASE of the TV. 2 2 Remove the screws that hold the stand on. STAND BODY M4 x 20 STAND BASE 3 Assemble the TV as shown.
PREPARATION 47/55LV555H INSTALLATION DETACHMENT PREPARATION Carefully place the TV screen side down on a cushioned surface to protect the screen from damage. 1 1 Carefully place the TV screen side down on a cushioned surface to protect the screen from damage. AC IN CABLE MANAGEMENT AC IN CABLE MANAGEMENT Assemble the parts of the S TAND BODY with the STAND BASE of the TV. 2 STAND BODY M4 x 12 STAND BASE 3 Assemble the TV as shown. 4 Install the 4 screws into the holes shown.
CABLE MANAGEMENT ■ Image shown may differ from your TV. 32/37/42LG710H Connect the cables as necessary. To connect additional equipment, see the EXTERNAL EQUIPMENT SETUP section. To help prevent the power cable from being removed by accident, secure the power cable with the included P ROTECTIVE BRACKET /SCREW. The 32LG710H use a Plug-in type Holder instead of using a screw. 3 ! NOTE PROTECTIVE BRACKET/SCREW G Do not hold the CABLE MANAGEMENT CLIP when moving the TV.
PREPARATION 32/37/42/47/55LD650H, 32/37/42LD655H, 32/37/42LD660H, 32/37/42LD665H PREPARATION 1 Connect the cables as necessary. To connect additional equipment, see the EXTERNAL EQUIPMENT SETUP section. To help prevent the power cable from being removed by accident, secure the power cable with the included PROTECTIVE BRACKET /SCREW. The 32/37/42LD650H, 32/37/42LD655H, 32/37/42LD660H, 32/37/42LD665H use a Plug-in type Holder instead of using a screw.
32/37/42/47/55LV555H Gether and bind the cables with the cable holder on the TV back cover.
PREPARATION DESKTOP PEDESTAL INSTALLATION ■ Image shown may differ from your TV. For proper ventilation, allow a clearance of 4 inches on all four sides from the wall. PREPARATION 4 inches 4 inches 4 inches 4 inches CAUTION G G Ensure adequate ventilation by following the clearance recommendations. Do not mount near or above any type of heat source. SWIVEL STAND After installing the TV, you can adjust the TV set manually to the left or right direction to suit your viewing position.
ATTACHING THE TV TO A DESK The TV should be attached to a desk so it cannot be pulled in a forward/backward direction, potentially causing injury or damaging the product.
PREPARATION 47/55LD650H, 47/55LV555H Stand PREPARATION 4-Screws (not provided as parts of the product) Desk EXCEPT 47/55LD650H, 47/55LV555H Stand 1-Screw (provided as parts of the product) Desk WARNING G 28 To prevent TV from falling over, the TV should be securely attached to the floor/wall per installation instructions. Tipping, shaking, or rocking the TV may cause injury.
VESA WALL MOUNTING A B VESA (A * B) Model 32LG710H A B 200 * 100 Standard Screw Quantity M4 4 Wall Mounting Bracket (sold separately) RW230 37LG710H, 42LG710H 200 * 200 M6 PREPARATION Install your wall mount on a solid wall perpendicular to the floor. When attaching to other building materials, please contact an installer. If installed on a ceiling or slanted wall, it may fall and result in severe personal injury.
PREPARATION ! NOTE PREPARATION G G G G G Screw length needed depends on the wall mount used. For further information, refer to the instructions included with the mount. Standard dimensions for wall mount kits are shown in the table. When purchasing our wall mount kit, a detailed installation manual and all parts necessary for assembly are provided. Do not use screws longer then the standard dimension, as they may cause damage to the inside of the TV.
SECURING THE TV TO THE WALL TO PREVENT FALLING WHEN THE TV IS USED ON A STAND ■ You should purchase necessary components to prevent the TV from tipping over (when not using a wall mount). Image shown may differ from your TV. We recommend that you set up the TV close to a wall so it cannot fall over if pushed backwards. Additionally, we recommend that the TV be attached to a wall so it cannot be pulled in a forward direction, potentially causing injury or damaging the product.
