HW994SJ-AHP_BUSAJJK DVD DIGITAL THEATER SYSTEM TH-G51J Consists of XV-THG51, SP-THG51F, SP-THG61C, SP-THG50W and RX-THG51 TUNING TUNING iPod is a trademark of Apple Inc., registered in the U.S. and other countries. For Customer Use: INSTRUCTIONS Enter below the Model No. and Serial No. which are located on the rear of cabinet. Retain this information for future reference. Model No. Serial No.
CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR BACK) NO USER-SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. This lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated dangerous voltage within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
NOTE TO CABLE/TV INSTALLER: This reminder is provided to call the cable TV system installer’s attention to Article 820-40 of the National Electric Code (U.S.A.). The code provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of the cable entry as practical. FCC WARNING: This equipment may generate or use radio frequency energy.
IMPORTANT SAFETY INSTRUCTIONS CAUTION: PLEASE READ AND OBSERVE ALL WARNINGS AND INSTRUCTIONS IN THIS OWNER’S MANUAL. AND THOSE MARKED ON THE PRODUCT. RETAIN THIS BOOKLET FOR FUTURE REFERENCE. This product has been designed and manufactured to assure personal safety. Improper use can result in electric shock or fire hazard. The safeguards incorporated in this product will protect you if you observe the following procedures for installation, use, and servicing.
Contents Introduction . . . . . . . . . . . . . . . . . . .2-5 About the Symbol Display . . . . . . . . . . . . . .2 Symbol Used in this Manual . . . . . . . . . . . . . . .2 Screen Saver . . . . . . . . . . . . . . . . . . . . . . . . . . .2 Notes on Discs . . . . . . . . . . . . . . . . . . . . . . . . . .2 Handling Discs . . . . . . . . . . . . . . . . . . . . . . . .2 Storing Discs . . . . . . . . . . . . . . . . . . . . . . . . .2 Cleaning Discs . . . . . . . . . . . . . . . . . . . . . . . .
Introduction To ensure proper use of this product, please read this owner’s manual carefully and retain it for future reference. Notes on Discs Handling Discs This manual provides information on the operation and maintenance of your DVD player. Should the unit require service, contact an authorized service location. Do not touch the playback side of the disc. Hold the disc by the edges so that fingerprints do not get on the surface. Never stick paper or tape on the disc.
Notes: • Depending on the conditions of the recording equipment or the CD-R/RW (or DVD±R/RW) disc itself, some CD-R/RW (or DVD±R/RW) discs may not be played on the unit. • Do not use irregularly shaped CDs (e.g., heartshaped or octagonal) since they may result in malfunctions. • This unit requires discs and recordings to meet certain technical standards in order to achieve optimal playback quality. Pre-recorded DVDs are automatically set to these standards.
Front Panel a b c a 1/' (STANDBY/ON) Switches the unit ON and OFF. b Disc Tray Insert a disc here. c AUDIO IN The AUDIO IN port means you can connect a audio device to play through the surround sound speakers. d Z (OPEN/CLOSE) Opens or closes the disc tray. e x (STOP) Stops playback. f B (PLAY) Starts playback. SOURCE Press and hold down this button about 3 seconds, then press repeatedly to select other function d e f g hi g X (PAUSE) Pause playback.
Remote Control 0-9 numerical buttons: Selects numbered options in a menu. Introduction SURROUND Selects the surround mode. SCAN MODE Sets the output resolution for HDMI and COMPONENT VIDEO OUT jacks. Installation and Setup SUBTITLE Selects a subtitle language (DVD). PROG./MEMO. Accesses or removes Program menu. Enter a radio station’s frequency into the tuner. REPEAT Repeats chapter, track, title, all Remote Control operation Point the remote control at the remote sensor and press the buttons.
Installation and Setup TV Connection Video connection Make one of the following connections, depending on the capabilities of your existing equipment. Connect the MONITOR OUT jack from the DVD/CD Receiver to the VIDEO IN jack on the TV using the video cable (V). Tips: Depending on your TV and other equipment you wish to connect, there are various ways you could connect the DVD/CD Receiver. Use one of the connections described below.
Optional Equipment Connection iPod connection (I) Introduction Connect the iPod and the unit with iPod docking station.(I). Rear of DVD/CD Receiver iPod A (not supplied) O H (not supplied) OUT I (supplied) IN VIDEO AUDIO (R) OPTICAL Installation and Setup AUDIO (L) Rear of DVD/CD Receiver OUT AUX IN connection (A) Connect a Output of auxiliary device to the AUX AUDIO Input (L/R) Connector.
HDMI Connection About HDMI HDMI compatible TV HDMI (High Definition Multimedia Interface) supports both video and audio on a single digital connection for an easy all- digital output to an HDMI or DI-equipped TV. HDMI H Connection to an HDMI TV requires an HDMI cable while connection to a DVI-equipped TV requires a DVI adapter besides a HDMI cable.
Note: If there is a product with a strong electromagnetic field nearby, interference may occur. (Ex : Micro wave oven) LED indicator of Wireless Receiver * LED indicator - “BLUE” The Wireless Receiver is receiving the signal of the Wireless transmitter. * LED indicator - “RED” The Wireless Receiver is in standby mode. Initial Setting an ID of Wireless 1 Connect the Wireless Receiver and the rear speaker (right, left) with the speaker cables.
Speaker System Connection Caution: Connect the speakers using the supplied speaker cables. • The left and right speakers can be installed on a wall. • When installing the speakers on a wall, be sure to have the speakers installed by qualified personnel. • DO NOT install the speakers on the wall by yourself to avoid unexpected damage from them falling off the wall due to incorrect installation or weakness in wall structure. • Care must be taken in selecting a location for speaker installation on a wall.
1. Press DISPLAY to show various playback information. The displayed items differ depending on the disc type or playing status. By using the Setup menu, you can make various adjustments to items such as picture and sound. You can also set a language for the subtitles and the Setup menu, among other things. For details on each Setup menu item, see pages 11 to 14. Introduction You can display various information about the disc loaded on-screen.
General Operation DISPLAY 1. Press SETUP. The Setup menu appears. TV Aspect 4:3 – Select when a standard 4:3 TV is connected. 2. Use v / V to select the desired option then press B to move to the second level. The screen shows the current setting for the selected item, as well as alternate setting(s). Display Mode The Display Mode setting works only when the TV Aspect mode is set to 4:3. 3. Use v / V to select the second desired option and then press B to move to the third level.
5.1 Speaker Setup Each DVD disc has a variety of audio output options. Set the player’s AUDIO options according to the type of audio system you use. Make the following settings for the built-in 5.1 channel surround decoder. Introduction AUDIO Installation and Setup 1. Press ENTER, and the 5.1 Speaker Setup menu appears. Dynamic Range Control (DRC) Set Vocal to On only when a multi-channel karaoke DVD is playing. The karaoke channels on the disc will mix into normal stereo sound.
5.1 Speaker Setup Test Press b / B to test the signals of each speaker. Adjust the volume to match the volume of test signals memorized in the system. Front Left (Front L) → Center→ Front Right (Front R) → Rear Right (Rear R) → Rear Left (Rear L) → SubWoofer LOCK (Parental Control) Rating Blocks playback of rated DVDs based on their contents. Not all discs are rated. 1. Select “Rating” on the LOCK menu then press B. 2. Input a password and press ENTER. 3.
Operation General features Buttons Operations Discs Z (OPEN / CLOSE) Opens or closes the disc tray. ALL X (PAUSE) During playback, press X to pause playback. ALL Press X repeatedly to play Frame-by-Frame. DVD During playback, press . or > to go to the next chapter/track or to return to the beginning of the current chapter/track. ALL ./> Press . twice briefly to step back to the previous chapter/track. During playback, press m or M repeatedly to select the required scan speed.
Additional features Time Search DVD To start playing at any chosen time on the disc: 1. Press DISPLAY during playback. 2. Press v / V to select the time clock icon and “--:--:--” appears. 3. Input the required start time in hours, minutes, and seconds from left to right. If you enter the wrong numbers, press CLEAR to remove the numbers you entered. Then input the correct numbers. 4. Press ENTER to confirm. Playback starts from the selected time. 1.5 times speed playback DVD You can play at 1.
Playing an Audio CD or MP3/WMA file ID3 TAG When playing a file containing information such as track titles, you can see the information by pressing DISPLAY. (Song, Artist, Album, Genre, Comment) This unit can play Audio CDs or MP3/WMA files.
Programmed Playback The program function enables you to store your Favourite tracks from any disc in the receiver memory. A program can contain 30 tracks. 1. Insert a disc. Audio CD and MP3/WMA Discs: 2. To add a music(s) on the program list, press PROG/MEMO to enter the program edit mode ( E mark appears on the menu). 3. Select a desired music on the [List] by using the v / V then press ENTER to add the music to the program list. 4.
Still Picture Viewing a JPEG file This unit can play discs with JPEG files. Before playing JPEG recordings, read the notes on JPEG Recordings on the right. 1. Insert a disc and close the tray. The PHOTO menu appears on the TV screen. 1. Press PAUSE/STEP during the slide show. The DVD/CD Receiver will now go into the PAUSE mode. 2. To return to the slide show, press PLAY or press PAUSE/STEP again. Moving to another File Press SKIP (.
Using iPod iPod message For detial refer to iPod guide. iPod mode: You can operate your iPod by using the supplied remote control and directly control on your iPod. OSD iPod mode: You can operate your iPod by controlling OSD menu on the TV screen with supplied remote control. The controls on your iPod are not operational in the OSD iPod mode. “Please, check your iPod” - If the power of your iPod is insufficient or the iPod is misconnected or unknown device.
Presetting the Radio Stations Listening to the Radio You can preset 50 stations for FM. Before tuning, make sure that you have turned down the volume. Preset radio stations in the DVD/CD Receiver’s memory first (see “Presetting radio stations” on the left). 1. Press FUNCTION on the remote control until FM appears in the display window. 2. Press and hold TUNING.(-/+) for about two seconds until the frequency indication starts to change, then release.
Sleep Timer Setting You can set the DVD/CD Receiver to turn off automatically at a specified time. 1. Press SLEEP to set the desired sleep time. The SLEEP indicator and the sleep time appears in the display window. 2. Each time you press SLEEP the setting changes in the following order. SLEEP 180 →150 →120→90 →80 → 70 → 60→ 50 → 40 → 30 → 20 →10 →OFF (No display) Note: You can check the remaining time before the DVD/CD Receiver turns off. Press SLEEP. The remaining time appears in the display window.
Language Codes Use this list to input your desired language for the following initial settings: Disc Audio, Disc Subtitle, Disc Menu.
Troubleshooting Check the following guide for the possible cause of a problem before contacting service. Symptom Cause No power. • The power cord is disconnected. • Plug the power cord securely into the wall outlet. The power is on, but the DVD/CD Receiver does not work. • No disc is inserted. • Insert a disc. (Check that the DVD or, audio CD indicator in the DVD display is lit.) No picture. • The TV is not set to receive DVD signal output.
The remote control does not work properly. The front panel display is too dim. Correction • Connect the antenna securely. • Adjust the antennas and connect an external antenna if necessary. • The signal strength of the stations is too weak (when tuning in with automatic tuning). • Tune in the station manually. • No stations have been preset or preset stations have been cleared (when tuning by scanning preset stations). • Preset the stations (page 21).
Specifications Speakers Amplifier FM Tuner Video CD/DVD General Power supply Power consumption Net Weight External dimensions (W x H x D) Operating conditions Operating humidity Laser Video system Frequency response (audio) Signal-to-noise ratio (audio) Dynamic range (audio) Harmonic distortion (audio) Video output COMPONENT VIDEO OUT HDMI OUT Tuning Range Intermediate Frequency Signal-to Noise Ratio Frequency Response Stereo mode Surround mode (* Depending on the sound mode settings and the source,
Reference WARRANTY (Only in U.S.A.
TH-G50J 0409SKMLGEEGL