User Manual Wireless Charger (HLW-TNHP1)
1. Introduction 1.1 Overview This module support WPC Qi standard and it will not be released as a stand-alone product but it will be released as built-in product. A 6mm plastic gap is required on the top for wireless charging of the module alone 1.
2. How to Use 2.1 Wireless charging 1. Connect 12V/3A DC power source via power connector. 2. Put down mobile phone at the center of charger model (Attach 6mm thick insulating material (plastic, wood, paper, rubber, etc.) when charging the product by itself) 3. Check the charge icon on the mobile device screen for charging status 3.
2.2 Application Example This example represents some of the forms that are applied as built-in products 3. Specification 1 Model Name HLW-TNHP1 2 Input Power DC 12V/3.0A 3 Operating Temperature -40~50C 4 Dimension 125(W)x98(D)x21.
FCC Notice This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Industry Canada Statement This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept any interference, including interference that may cause undesired operation of the device.
Declaration of Conformity Hereby, HITACHI-LG DATA STORAGE, Inc. declares that the radio equipment type Wireless Charger is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: http://www.lg.com/global/support/cedoc/cedoc# For consideration of the user, this device should be installed and operated with a minimum distance of 15 cm between the device and the body. Manufacturer name: HITACHI-LG DATA STORAGE, Inc.