User's Manual

ManualsBrandsLG Electronics USA ManualsCell PhonesPCS GSM Phone

Basic Operation

•

Kisekae Tool can also be set using the following steps.

Stand-by display X

X I[Kisekae] X move

the cursor to "i-mode"/"Preinstalled" X

C[Open]

•To reset the setting, press

[Menu] on the Kisekae

Tool list screen X "Reset screen display / sound

setting" X enter the Terminal security code.

Information

Changing Illumination when Receiving

Stand-by display X M X "Settings" X

"Display" X "Lighting LED" X Move the

cursor to "Lighting LED" X C[ON]

"Incoming voice call"/"Incoming video

call"/"New mail" X Select an illumination

pattern

I[Done]

Checking Missed Calls or New

Mails with Lighting

Stand-by display X M X "Settings" X

"Display" X "Lighting LED" X Move the

cursor to "Lighting LED" X C[ON]

Move the cursor to "Missed call" or

"Unread message" X C[ON]

I[Done]

•The illumination for "Missed call" lights or blinks in Aqua

color for approximately six hours at approximately ﬁ ve

second interval.

The illumination for "Unread message" lights or blinks in

Green color for approximately six hours at approximately

ﬁ ve second interval.

Information

Saving Power Consumption

Set the backlight brightness of the display to the

lowest power saving level, and set the backlight to

be turned off when 10 seconds elapsed after the

last operation.

Stand-by display X M X "Settings" X

"Other" X "eco mode" X "ON"/"OFF"

•Alternatively, press 5 for over 1 second in Stand-by to

set/cancel the eco mode.

Information

Summary of content (20 pages)

PAGE 1
Information Kisekae Tool can also be set using the following steps. Stand-by display X M X I[Kisekae] X move the cursor to "i-mode"/"Preinstalled" X C[Open] • To reset the setting, press M[Menu] on the Kisekae Tool list screen X "Reset screen display / sound setting" X enter the Terminal security code.
PAGE 2
Lock/Security Various Security Codes ● • • • Avoid setting security codes using your birthday, part of your phone number, your address or room number, "1111" or "1234" that can be easily guessed by others. Be sure to write down the set security codes and store them in a separate location. Do not reveal your security codes to others. DOCOMO is not responsible for damage caused by misuse of your security codes by others.
PAGE 3
Basic Operation i-mode password (At the time of contract: 0000) 32 The "i-mode password" is a 4-digit number required to register/remove contents in My Menu, and subscribe to/cancel the message service or fee-based i-mode services. (Some other information service providers may set individual passwords.) You can change the password by yourself. From i-mode, you can change it by accessing "iMenu" X "English" X "Options" X "Change i-mode Password".
PAGE 4
Various Lock Functions Lock function Lock all Description Description Omakase Lock Locks your personal data such as Phonebook and IC card functions of Osaifu-Keitai by calling DOCOMO when you lost the FOMA terminal. Setting/Canceling Omakase Lock 0120-524-360* Available 24 hours a day (open all year round) (Japanese only) * Unavailable from part of IP phones. • Can be set/canceled from the My docomo site (Japanese only) using a PC.
PAGE 5
Basic Operation Lock function 34 Description Self mode Disables all functions that require communication, such as making/ receiving calls, using i-mode, or sending/receiving mails. 1 Stand-by display X M X "Settings" X "Call/VT/Dialing" X "Self mode" X "Yes"/"No" Data access lock Specifies and locks functions to prevent unauthorized use by others.
PAGE 6
Restricting Incoming Calls Resetting to Default Resetting various function settings to defaults Reject incoming calls without caller ID per reason for anonymous call. Reset the settings you have changed in functions to defaults. 1 Stand-by display X M X "Settings" 1 Stand-by display X M X "Settings" Rejecting calls from callers unset in Phonebook Deleting all saved data at once Set to reject calls from callers not saved to Phonebook or without caller ID.
PAGE 7
Call Telephone This FOMA terminal is not equipped with Inner camera. So the image sent to the other party during videophone call is a still image or current image captured with Outer camera. Making a Call/Videophone Call Entering a phone number to make a call Connect 1 Enter a phone number • Start with a city code even for a local call. 2A A ringing tone sounds from the earpiece, and the Dialing screen is displayed until the other party answers the call. b To make a videophone call Press I[V. phone].
PAGE 8
Notifying other party of your phone number • Set whether to notify/not to notify other party of your caller ID on the network beforehand. 1 Stand-by display X M X "Settings" X 2 "NW Services" X "Caller ID notification" X "Activate/Deactivate" "Notify"/"Not notify" Information • If you hear a guidance asking to notify of your caller ID, set the caller ID notification or prefix 186 to the other party's phone number and call again.
PAGE 9
2A b During a videophone call Press I[Camera/Image] to switch the image to send between the camera image and the substitute image. 3 To end the call, P Adjusting Earpiece Volume 1 During a call, Navigation Up/Down key Connect When You cannot Answer a Call Setting Record message If the Record message is activated, the voice guidance is played when you cannot answer a voice call and the other party's message is recorded. • The Record message does not activate when a videophone call arrives.
PAGE 10
Setting Public mode (Power OFF) When a call arrives while the power is turned OFF, the guidance is played announcing that you cannot answer the call because you are in a place where you should turn the power OFF (hospital, airplane, near priority seats on a train), and then the call is disconnected. display X Enter ":25251" X A 1 Stand-by b To cancel the Public mode (Power OFF) In Stand-by, enter ":25250" and press A.
PAGE 11
Setting Voice mail service Available service 1 Stand-by display X M X "Settings" X City code of the desired area + 177 Emergency calls to police (No prefix) 110 Emergency calls to fire station and ambulance (No prefix) 119 Emergency calls for accidents at sea (No prefix) 118 Disaster emergency message dial (Charges apply) (No prefix) 171 Setting Call forwarding service Collect calls (Charges apply: guidance fee + call fee) (No prefix) 106 1 Stand-by display X M X "Settings" X "NW • "NW Serv
PAGE 12
Using Overseas International roaming (WORLD WING) is a service that allows you to use the FOMA terminal used domestically in a service area of international carrier associated with DOCOMO, with the same phone number and mail address. You can use voice call, SMS, and i-mode mail functions without changing settings. ● Available area This FOMA terminal can be used in 3G network and GSM/GPRS network service areas. Check available areas. ● Before using the FOMA terminal overseas, see the following items.
PAGE 13
Available services Communication service Voice call*1 Videophone*1 Connect SMS*2 i-mode*3 i-mode mail i-Channel*3*4 Packet communication by connecting to a PC 42 3G ○ ○ ○ ○ ○ ○ GSM ○ × ○ × × × GPRS ○ × ○ ○ ○ ○ ○ × ○ *1 When you use Multi number, you cannot make a call using Additional number. *2 If you send a message to the FOMA terminal user, enter the other party's phone number in the same operation as in Japan. *3 You need to make overseas usage settings for i-mode.
PAGE 14
2A 2A Making a call to a person in the country you stay Receiving a call overseas b To make a videophone call Press I[V. phone]. Make a call by dialing the other party's phone number from the area code (city code). display X Enter "Area code 1 Stand-by (City code) - Other party's phone number" 2 A To make a videophone call Press I[V. phone]. Making a call to WORLD WING user overseas To make a videophone call Press I[V. phone]. 1 A call arrives 2A Answer a call.
PAGE 15
Mail Sending i-mode Mail Upon subscription to i-mode, you can exchange e-mail via the Internet, as well as between i-mode terminals. • For details on i-mode mail, see "Mobile Phone User's Guide [i-mode] FOMA version".
PAGE 16
Sending Deco-mail Create your designed mail by adding decorations such as changing font size, font color or background color, or inserting images when editing i-mode mail. 6 C[Set] X I[Send] Viewing Received i-mode Mail When the FOMA terminal is in the service area, i-mode mail is automatically sent from the i-mode center. When i-mode mail arrives, 1 the top of the screen appears at When the reception completes, the Receive results screen appears.
PAGE 17
Replying to i-mode mail Sorting mails Reply to the sender of i-mode mail. Replying can be made by entering new text or quoting the text of the received i-mode mail. Set sorting criteria to automatically save mails to specified folders. • Create sorting folders in "Inbox" and "Outbox" beforehand.
PAGE 18
Using SMS Viewing received SMS Sending SMS SMS messages are sent automatically when the FOMA terminal is in the service area. Send a message addressed to a mobile phone number. SMS arrives, 1 When the screen 1 Stand-by display X g X "SMS" X "Compose SMS" 3 Select field X Enter a message 4 I[Send] When the reception completes, the Receive results screen appears.
PAGE 19
Phonebook Two types of Phonebooks are available with the FOMA terminal: FOMA terminal Phonebook to be saved on the FOMA terminal and UIM Phonebook to be saved on the UIM. Entry items that can be saved/ set for each Phonebook are as follows.
PAGE 20
Adding Phonebook entries from redial or received calls display X Navigation Right key 1 Stand-by (Redial) or Navigation Left key (Recv. Calls) the cursor to the phone number to 2 Move add X C[Detail] X M[Menu] X "Add to phonebook" display X Navigation Down key 1 Stand-by X Select the entry to delete X M[Menu] X "Delete" 2 "Yes" Checking Phonebook Storage Status Check the Phonebook storage status of the FOMA terminal and UIM. 1 Stand-by display X M X "Phonebook" X "No.