User's Manual
The antenna(s) must be installed such that a minimum separation distance of at least 20 cm is 
maintained between the radiator (antenna) and all persons at all times. This device must not be co-located 
or operating in conjunction with any other antenna or transmitter. 
End Product Labeling 
The module is labeled with its own FCC ID and IC Certification Number. If the FCC ID and IC 
Certification Number are not visible when the module is installed inside another device, then the 
outside of the device into which the module is installed must also display a label referring to the 
enclosed module. In that case, the final end product must be labeled in a visible area with the 
following: 
“Contains FCC ID: BEJ-LGHALCW1502” 
“Contains IC: 2703N-LGHALCW1502” 
<IC Warning Statements> 
RSS-GEN, Sec. 7.1.3 – (licence-exempt radio apparatus) 
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the 
following two conditions: (1) this device may not cause interference, and (2) this device must accept any 
interference, including interference that may cause undesired operation of the device. 
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de 
licence. L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de 
brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le 
brouillage est susceptible d’en compromettre le fonctionnement. 
RF Exposure 
The antenna (or antennas) must be installed so as to maintain at all times a distance minimum of at least 20 
cm between the radiation source (antenna) and any individual. This device may not be installed or used in 
conjunction with any other antenna or transmitter. 
l'exposition aux RF 
L’antenne (ou les antennes) doit être installée de façon à maintenir à tout instant une distance minimum de 
au moins 20 cm entre la source de radiation (l’antenne) et toute personne physique. 
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void 
your authority to operate thisequipment.Attention: 





