User's Manual

ENGLISH
2
1. Turn off your computer and all attached devices.
2. Connect the signal cable.
The AC adapter and the analog signal cable are already connected to
your monitor
When connecting the analog signal cable (Figure A)
Connect free end of the attached signal cable to the Dsub connector on the
computer and tighten the screws.
When connecting the DVI signal cable
(Figure B)
Connect one end of the monitor signal cable to the DVI connector on the rear
panel of the monitor. Connect the other end to the DVI port on the rear panel
of the computer and tighten the screws.
3. Connect the power cord to the power adapter and then plug the power
cord into a properly grounded outlet.
1. Switch on the power source to your monitor.
2. Switch on your monitor by pushing and releasing the power switch
marked [ ].
[To switch off your monitor, push and release the power switch again.]
3. Switch on your computer.
4. Run AUTO SETUP by following the instructions in the Auto Setup
section on page 6.
Connecting your Monitor
Switching on your Monitor
(Figure A)
(Figure B)
Monitor Installation
ENGLISH