LG Telematics Test Manual [Gen90LNB] Version 1.0 2009.07.
LG Telematics Revision History Author Sangjin Han Description Merged document.
LG Telematics Contents 1. How to Place a Call 2. ATT Tool for TCU Setting 3.
LG Telematics 1. How to Place a Call Fig.
LG Telematics
LG Telematics 2. ATT Tool for TCU Setting 1) Set COM Port Fig 18 2) Check Connection Status Fig.
LG Telematics 3) NAD Screen Fig.20 4) Select Forced band mode and apply it Fig.
LG Telematics - Click to see the selectable menu for changing - After select the Service mode, click “Control” to apply it. Fig.22 5) Check result of change. Fig.
LG Telematics 3. VCP Commander 1) Run “VCP-Commander.exe”. This tool is single executable file. 2) Connect the named “CAIT”-port to your PC’s serial port. 3) Check the serial baud rate of VCP. (Power-up default is 38400 bps) 4) Select your PC’s COM-port, Press “Connect” button. 5) Test the right connection. Press “END”, verify that “Status” is flipped (“Cmd FAIL” to “Cmd OK”). Fig.25 6) Select command from drop-down-list and enter “Value 1” or “Value 2” according to each command.
LG Telematics A_KEY See See example 1 example 1 PREF_FOR_RC 1~5 Don’t care Set NV_PREF_FOR_RC_I IMSI_MCC 3-digit Don’t care Set NV_IMSI_MCC_I Don’t care Set NV_IMSI_11_12_I decimal Set A-key value ie.
LG Telematics FCC Information FCC part 15.19 This device complies with Part 15 of the FCC Rules, Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Part 15.21 statement Change or Modifications that are not expressly approved by the manufacturer could void the user's authority to operate the equipment.