HSPA USB Modem LUU-2100TI User Guide
Part 15.21 statement " Change or Modifications that are not expressly approved by the manufacturer could void the user's authority to operate the equipment. “ Part 15.105 statement This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Part 15 Class B Compliance This device and its accessories comply with part15 of FCC rules. Operation is subject to the following two conditions: (1) This device & its accessories may not cause harmful interference. (2) This device & its accessories must accept any interference received, including interference that may cause undesired operation.
Copyright LGE Co., Ltd holds the copyright for this manual. This manual should not be reproduced or distributed without prior written consent by LGE Co., Ltd. Registered Trademark The registered trademark used in this manual is a registered trademark owned by the corresponding company. Confidential & Proprietary This manual is the technical property of LGE Co., Ltd and it is prohibited to copy or utilize the manual without prior consent from the technical data department.
Introduction Thank you for purchasing LUU-2100TI from LGE Co., Ltd. The LUU-2100TI is a USB Modem using HSPA for wireless internet anytime and anywhere. *H SPA (High Speed Packet Access): This is a mobile communication technology for sending/receiving data at a significantly faster speed than that of W-CDMA or CDMA.
Configuration The configuration of the LUU-2100TI product is as shown below: Main Body Manual USB Extension Cable The configuration of the product may be changed without prior notice to improve the functions of the product.
Name of Each Part ó Front Part ó Rear Part ó Side Part Micro SD Slot LED Display USB Port ó Lower Part
How to install USB driver 1 Unzip “LGUSBNDISDriver_WHQL_Eng_Ver_1.0_All.zip” file 2 Connect LUU-2100TI USB modem to laptop 3 It will be detected as “mass storage” device 4 Run “LGUSBNDISDriver_WHQL_Eng_Ver_1.0_All.
6 And installation will be executed
7 Press “OK” button 8 Unplug and plug LUU-2100TI USB modem
