WLAN UNIT & Accessories WLAN UNIT LGE Internal Use Only WLAN UNIT Holder 1/8 Screw(2ea)
WLAN UNIT setting(Connection) LGE Internal Use Only Smart Washing Machine ※ To ensure compliance p with FCC RF exposure p requirements, q this device must be installed in a location where the antenna of the device will have a minimum distance of at least 10 cm 2/8 WLAN UNIT connected to Washing Machine
WLAN UNIT setting(Smart Phone ) LGE Internal Use Only 1. Access LG Smart Server Homepage with computer (http://www.smartthinQ.com) and register ID and password. d 4. Set the requirement of Wi-Fi Modem which is on the product with i h pushing hi the”Product h d S Setting i Mode” d below. b l 1 2. Apply purchased WLAN UNIT to Smart Washing Machine, push the reservation button for more than 3 sec. after turning on the washing machine. shows ‘Wi-Fi Wi Fi Setting mode with “Ting” Ting sound.
WLAN UNIT Setting (Product) ) 18:88 shows Error type when it is failed, or Set mode entering has canceled without any setting (Cancel in Web or App) • User contacts the Setup mode and save the SSID/Password and user’s information for product registration. • Enter Wi-Fi Setting Mode after pushing Time Delay or Delay Wash (W) / Time Dry for 3 sec.
Smart Grid Function Application - electric product is operating with DR Signal from electric Power company(Hyb, Cloud included). - Follow AHAM standard standard. - DR Signal Acceptable with Smart On button activated and Modem is in. - When DR signal is in, receive DL/SR separately(Duration time >10 : DL else SR), SR) with this signal product is operating Delay Start and Energy Save motion by itself. But for this product, do not guide to customers Smart on Smart on 1.
Smart Diagnosis Final saved Diagnosis factor sends to server when pushing the Smart Diagnosis button(Washing machine: water temp. dryer: temp.) In case of Audible, information of 1 cycle only will be sent because of time restraint(sending takes about 15 sec.) Wi-Fi also send the final saved diagnosis factor to server server. Function Definition by detailed using Scene will be identified after additional consulting. Application will be also identified after additional consulting. Wi-Fi also can check.
Smart Access : Access and Adapt is available after WLAN UNIT Setting completion. In case of going out or getting to work after operating Washing Machine, Smart Phone can power off or monitor washing machine. < Function Application > 1. Smart Remote Control Function Definition 1-1. Power On/Off Function Definition 1 1 1 Power On : Power can not be On under any circumstance from exterior 1-1-1. exterior. 1-1-2.
FCC Notice THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. RULES OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDERSIRED OPERATION. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.