LG-TM540 User Guide CDMA/AMPS/PCS TRI-MODE PHONE
FCC RF EXPOSURE INFORMATION WARNING! Read this information before using your phone In August 1996 the Federal Communications Commission (FCC) of the United States with its action in Report and Order FCC 96-326 adopted an updated safety standard for human exposure to radio frequency electromagnetic energy emitted by FCC regulated transmitters. Those guidelines are consistent with the safety standard previously set by both U.S. and international standards bodies.
Contents Introduction Highlights Important Information Check Accessories Before You Start FCC RF EXPOSURE INFORMATION Chapter 1. Getting Started Cautions Phone Overview On screen Icons Chapter 2. Basic Functions Turning the Phone On and Off Making a Call Correcting Dialing Mistakes Receiving Calls Using Quick Mode Call Waiting Mute Redialing Calls Adjusting the Volume Power Save Mode Signal Strength Emergency Dialing Mini Display Speed Dialing Caller ID Phone Book Features Chapter 3.
Send Msg New Text Old Text Erase All Setting Chapter 6. Functions used during a call Mute Memo Recording Key Tone Voice Privacy Chapter 7. Accessories Chapter 1. Getting Started Cautions l l l l l l l l l Using the phone in proximity to receiving equipment (i.e., TV or radio) may cause interference. Keep your phone in a safe place when not in use. Only use the batteries, antennas, and chargers provided by LG. Using the wrong accessories could void your warranty.
On screen Icons The phone screen displays several onscreen icons and onscreen icons appears when the phone is power on. Icons Descriptions Displays the strength of the signal received by the phone and current signal strength is indicated as the number of bars displayed on the screen. No service The phone is not receiving a system signal. In use A call is in progress. No icon indicates the phone is in standby mode. Digital indicator Digital service is available.
Turning the Phone Off 1. Press and hold until display screen will be turned off, and then release the key. 2. Protect the antenna by pushing it back into the phone, if extended. Making a Call When you make a call, follow these simple steps: 1. Make sure the phone is turned on. l If not, press [END/PWR]. 2. Enter the phone number with area code, if needed. 3. Press [SEND]. l If the phone is locked, enter the lock code. l “Call Failed” indicates that the call di d not go through. 4.
l Press digit, then press [SEND]. Two-Touch Dialing (Speed Dialing) : This dialing feature enables you to dial numbers in your phone book through two keys (for locations 10 to 99). 1) Press the first digit. 2) Press and hold the key of the second digit. OR 1) Press the first and second digits, then press [SEND]. Three-Touch Dialing (Speed Dialing) : This dialing feature enables you to dial numbers in your phone book through three keys (for location 100 to 199). 1) Press the first and second digits.
Key Volume ( [Menu] +[1]+[5] ) Adjust the key beep volume (the volume of sound on key pressing). Ear Volume ( [Menu] +[1]+[6] ) Adjust the earpiece volume during a call, by pressing the side keys. Alerts ( [Menu]+[1]+[7] ) 1. Fade ( [Menu]+[7]+[1] ) Set an alert to inform you when you have lost a call or lose services. 2. Minute ( [Menu]+[7]+[2] ) Alerts you 10 seconds before the end of every minute during a call. 3. Service ( [Menu]+[7]+[3] ) If on, alerts you when service changes.
l after 3 rings(or melody 10 seconds) l Machine Enable When you have incoming call, the phone automatically response with pre-recorded voice message and record caller’s speech after 3 rings. Auto Retry ([Menu]+ [3]+[3]) Set the length of time the phone waits before automatically redialing a number when the attempted call fails. l off / every 10 seconds / every 30 seconds / every 60 seconds One-Touch ([Menu]+ [3]+[4]) Enable/Disable one-touch dialing.
TTY Mode ([Menu]+ [4]+[5]) To enable or disable TTY mode, select ‘ TTY Mode “Enable”/”Disable” ‘ using [5] [6] or [v] key. If TTY mode is enabled, TTY Features is activated during call. Security ([Menu]+[5]) Lock code is commonly last 4 digit of your phone. (You must enter the lock code after pressing [Menu] ). If you need to modify the password, you may modify it using the “New Lock Code” of Security.
answering machine and playback the recorded message later. l To record the voice command, Press [CLR] key in Hands-Free Kit and record the voice command as per your preference. l When you hear “Incoming call answer?” in Hands -Free Kit, if the user say “yes” the call is connected, say “no” the bell rings. Voice Memo ([Menu]+[6]+[1]) When you are not available to answer the phone, the caller can leave the message into your voice mail and you can playback the recorded message later.
Allows you to keep a running count of the time you spend making calls in non-service area. To reset the call timer, press Soft Key 1 [Opt], and then select Soft Key 1 [Sel] after selecting [Zero] using the [v] key. 4. All Calls ([PIM]+ [1]+[4]+[4]) Allows you to keep a running count of the time you spend making all calls either in your service area or in non-service area. To set the call timer is not available.
Data/Fax : Entry of Data/Fax Number E-Mail : Entry of E-mail Address Find Email ([PIM]+[2]+[4]) 1. Press Soft Key 2 [PIM] 2. Press [Phone Book] [Find Email] l Select the item you want to view using the [v]. 3. Enter the Email address you want to search for and press [Find] key. If the Email address is found, the Email address will be displayed and if the Email address is not found, “Not Found” message will appear. 4.
- Move the cursor with the upside and downside keys, and press Softkey(SEL) for the menu requested. Press Softkey(BACK) to return to the initial image on the terminal. - Voice : Menu to check the number of voice messages in the voice mailbox - Send Msg: Menu to send message. - NewMsgs : Menu to check a new incoming text message - OldMsgs : Menu to check the verified but not erased text messages - Erase All : Menu to erase all the stored messages 1.
D 07/09 12:30p MESSAGE from 019-408-8144 I love you NEX DEL T . Select the ‘ DEL’ D - Erase This Message yes no 4. OldMsgs D >I love you DEL VIEW - It indicates the checked but not erased messages in the form of he list. - It indicates the checked and stored message in the form of the list. Move the location of > with the upside or downside key to select the message. 5. Erase All - This service enables erasing of all the messages stored by the message service.
3. ERRORS : View error class & CauseCode Chapter 6. Functions used during a call Mute (During a call : [MENU]+[1] ) l l Sometimes it is necessary to mute a call so that caller does not hear you or certain background noise. To use this function during a call, Press Soft Key 1 [Menu] and [1]. If you need to release mute press the Soft Key 1 [Menu] and [1] key again.
with hands-free operation. It will also charge a completely discharged battery in 5 hours. Hands-Free Car kit(Install) The installed hands-free car kit model IHF-54W is permanently installed in your car, and provides you with hands-free operation. It will also charge a completely discharged battery is shows. Data Cable Kit Connects your phone to your PC.(Model KW-a) Headset Connects to your phone, allowing hands free operation. Includes earpiece, microphone and mute key.