User's Instructions

10, Magokjungang 10-ro, Gangseo-gu, Seoul, Korea.
The device under test is manufactured by the grantee (LG Electronics USA), and sold as an
OEM product. Per 47 CFR 2.909, 2.927, 2.931, 2.1033, etc…, the grantee must ensure the
end-user has all applicable / appropriate operating instructions. When end-user instructions
are required, as in the case of this product, the grantee must notify the OEM to notify the end-
user.
LG Electronics USA will supply this document to the reseller/distributor dictating what must
be included in the end user’s manual for the commercial product.
INFORMATION TO BE INCLUDED IN THE END USER’S MANUAL
The following information (in blue) must be included in the end-product user’s manual
to ensure continued FCC and Innovation, Science and Economic Development Canada
regulatory compliance. The ID numbers must be included in the manual if the device
label is not readily accessible to the end user. The compliance paragraphs below must
be included in the user's manual.
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause
undesired operation.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :
1. L’appareil ne doit pas produire de brouillage;
2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
******************************************************************************
FCC ID: BEJWCFDM00N2A IC: 2703H-WCFDM00N2A
This equipment generates, uses, and can radiate radio frequency energy and may cause
harmful interference to radio communications. There is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, please consult the dealer.
This product is not end-user serviceable.
RF Radiation Exposure Statement: This equipment complies with FCC RF Radiation exposure
limits set forth for an uncontrolled environment. This device and its antenna must not be co-
located or operating in conjunction with any other antenna or transmitter. This equipment should
be installed and operated with a minimum distance of 20cm between the radiator and your
body.
This device complies with Part 15 of the FCC Rules and with Innovation, Science and
Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the
following two conditions: