Colour Television OWNER’S MANUAL BZ03 Please read this manual carefully before operating your set. Retain it for future reference. Record model number and serial number of the set. See the label attached on the back cover and quote this information to your dealer when you require service.
Installation Power Service This set operates on an AC mains supply, the voltage is as indicated on the label on the back cover. Never apply DC power to the set. In the event of thunderstorms or powercuts, please pull out the aerial and mains plugs. Press the POWER button on the front panel or side panel to turn off the TV when the TV set is not being used for a long time.It is recommended to remove the plug from the wall outlet(Power point).
Location and function of controls Remote control handset Before you use the remote control handset, please install the batteries. See the next page. 13. 14. 10 1 15. 16. 2 broadcast. (option) selects the sound output. LIST displays the programme table. SLEEP sets the sleep timer. SSM/ (Sound Status Memory) (option) recalls your preferred sound setting. º/ ) (option) SURROUND (º selects surround sound.
Basic operation On and off 1. Press the main power button to switch the set on. 2. If the set is in standby mode, press the POWER, D / E, TV/AV or NUMBER buttons on the remote control handset to switch it on fully. 3. Press the POWER button on the remote control handset. The set reverts to standby mode. 4. Press the main power button again to switch the set off.
On screen menus Setting up TV stations The dialogue between you and your set takes place on screen with an operator menu. The buttons required for the operating steps are also displayed. Menu selection 1. Press the MENU button and then D / E button to display each menu. 2. Press the G button and then D / E button to select a menu item. 3. Press the G button to display the sub menu or the pull-down menu. 4. Change the setting of an item in the sub or pull-down menu with the F / G or D / E.
Picture adjustment Note: Picture menu options are not available for the RGB input source. PSM (Picture Status Memory) You can also recall a desired picture (Dynamic, Standard, Mild, Game or User) with PSM button on the remote control. The picture Dynamic, Standard, Mild and Game are programmed for good picture reproduction at the factory and cannot be changed. CSM (Colour Status Memory) You can select the picture colour status; standard, reddish, greenish or bluish, as you prefer.
Time Setting Setting the On/Off timer Auto off By using this function, the set automatically switches on or off at a preset time. You must set the time correctly before using on/off time function. Note : a. On time works only in standby mode. b. To view the remaining on/off time, select the Time menu. c. When you switch the main power off, the Clock is reset . d.