OWNER’S MANUAL LED TV* * LG LED TV applies LCD screen with LED backlights. Please read this manual carefully before operating your set and retain it for future reference. MT35* MT55* MT75* www.lg.
TABLE OF CONTENTS ENGLISH TABLE OF CONTENTS 3 LICENSES 3 OPEN SOURCE SOFTWARE NOTICE 4 ASSEMBLING AND PREPARING 4 7 8 10 11 11 14 15 17 Unpacking Separate purchase Parts and buttons Lifting and moving the TV Setting up the TV - Attaching the Stand Mounting on a table Mounting on a wall Tidying cables 17 MAKING CONNECTIONS 18 18 18 19 Antenna Connection Satellite dish Connection Euro Scart Connection Other Connections 21 REMOTE CONTROL 22 USIng the user guide 23 MAINTENANCE 23 23 23 2
LICENSES / OPEN SOURCE SOFTWARE NOTICE 3 Supported licenses may differ by model. For more information of the licenses, visit www.lg.com. Manufactured under license from Dolby Laboratories. “Dolby” and the double-D symbol are trademarks of Dolby Laboratories. The terms HDMI and HDMI High-Definition Multimedia Interface, and the HDMI logo are trademarks or registered trademarks of HDMI Licensing LLC in the United States and other countries.
ASSEMBLING AND PREPARING ENGLISH NOTE yyImage shown may differ from your TV. yyYour TV’s OSD (On Screen Display) may differ slightly from that shown in this manual. yyThe available menus and options may differ from the input source or product model that you are using. yyNew features may be added to this TV in the future. yy The TV can be placed in standby mode in order to reduce the power consumption.
ASSEMBLING AND PREPARING 5 ENGLISH Remote control, Batteries (AAA) (See p.21) CD (Owner’s Manual), Cards Stand Base Stand Body Stand Body (Only MT55*, MT75*) (See p.12) Cable Tie (Only MT35*) (See p.11) (Only MT35*) (See p.11) (See p.17) Stand Base (Only MT55*, MT75*) (See p.12) Power Cord (See p.14) or AC-DC Adapter (See p.14) Component gender cable (See p.19, 20) Composite gender cable (See p.19, 20) Isolator (Depending on model) (See p.
ASSEMBLING AND PREPARING ENGLISH NOTE yy Antenna Isolator Installation Guide -- Use this to install TV in a place where there is a voltage difference between TV Set and GND of antenna signal. »» If there is a voltage difference between TV Set and GND of antenna signal, the antenna contact might be heated and excessive heat might cause an accident. -- You can improve the safety when watching TV by efficiently removing power voltage from TV antenna. It is recommended to mount the isolator to the wall.
ASSEMBLING AND PREPARING 7 Separate purchase items can be changed or modified for quality improvement without any notification. Contact your dealer to buy these items. These devices only work with certain models. The model name or design may be changed depending on the upgrade of product functions, manufacturer’s circumstances or policies.
ASSEMBLING AND PREPARING ENGLISH Parts and buttons MT35* Screen Remote Control Sensor Power Indicator yy Red : When the power is turned off yy Off : When the power is turned on Speakers Touch Buttons MT55* Screen Power Indicator yy yy Red : When the power is turned off Off : When the power is turned on Remote Control Sensor Speakers Touch Buttons MT75* Screen Speakers Remote Control Sensor Power Indicator yy Red : When the power is turned off yy Off : When the power is turned on Touch Buttons
ASSEMBLING AND PREPARING Touch button Description Scrolls through the saved programmes. Adjusts the volume level. OK Selects the highlighted menu option or confirms an input. SETTINGS Accesses the main menus, or saves your input and exits the menus. INPUT Changes the input source. Turns the power on or off. ENGLISH NOTE yy All of the buttons are touch sensitive and can be operated through simple touch with your finger. yy Power and control touch button are located on the bottom.
ASSEMBLING AND PREPARING ENGLISH Lifting and moving the TV Please note the following advice to prevent the TV from being scratched or damaged and for safe transportation regardless of its type and size. CAUTION yyAvoid touching the screen at all times, as this may result in damage to the screen. yyIt is recommended to move the TV in the box or packing material that the TV originally came in. yyBefore moving or lifting the TV, disconnect the power cord and all cables.
ASSEMBLING AND PREPARING 11 ENGLISH Setting up the TV Image shown may differ from your TV. 3 Attaching the Stand MT35* 1 CAUTION 2 yy When attaching the stand to the TV set, place the screen facing down on a cushioned table or flat surface to protect the screen from scratches. Stand Body NOTE Stand Base yy Remove the stand before installing the TV on a wall mount by performing the stand attachment in reverse.
ASSEMBLING AND PREPARING MT55* / MT75* ENGLISH 3 1 CAUTION 2 yy When attaching the stand to the TV set, place the screen facing down on a cushioned table or flat surface to protect the screen from scratches. Stand Body Stand Base or NOTE yy Remove the stand before installing the TV on a wall mount by performing the stand attachment in reverse.
NG OK ASSEMBLING AND PREPARING 13 CAUTION NG NG OK ENGLISH CAUTION yy Do not carry the monitor upside-down by holding the stand body (or stand base) as this may cause it to fall off, resulting in damage or injury. yy The illustration shows a general example of installation and may look different from the actual product.
ASSEMBLING AND PREPARING ENGLISH Mounting on a table Adjusting the angle of the TV to suit view 1 Lift and tilt the TV into its upright position on a table. Leave a 10 cm (minimum) space from the wall for proper ventilation. yy Image shown may differ from your TV. Tilt from +20 to -5 degrees up or down to adjust the angle of the TV to suit your view. -5 10 cm +20 10 cm 10 cm 10 cm Front 2 Connect the AC-DC Adapter and Power Cord to a wall outlet.
ASSEMBLING AND PREPARING 15 yy Image shown may differ from your TV. The Kensington security system connector is located at the back of the TV. For more information of installation and using, refer to the manual supplied with the Kensington security system or visit http://www.kensington. com. Connect the Kensington security system cable between the TV and a table. Mounting on a wall For proper ventilation, allow a clearance of 10 cm on each side and from the wall.
ASSEMBLING AND PREPARING ENGLISH Separate purchase(Wall Mounting Bracket) Model VESA (A x B) 24MT35* 27MT55* 27MT75* 100 x 100 Standard screw M4 x L10 Number of screws 4 Wall mount bracket (optional) RW120 yy VESA (A x B) CAUTION yy Disconnect the power first, and then move or install the TV. Otherwise electric shock may occur. yy If you install the TV on a ceiling or slanted wall, it may fall and result in severe injury.
ASSEMBLING AND PREPARING / MAKING CONNECTIONS 17 1 Gather and bind the cables with the Cable Tie. 2 Place the cable on the hook located on the stand base. This section on MAKING CONNECTIONS mainly uses diagrams for the 27MT55S models. Connect various external devices to the TV and switch input modes to select an external device. For more information about an external device’s connection, refer to the manual supplied with each device.
MAKING CONNECTIONS ENGLISH Antenna Connection Euro Scart Connection ANTENNA / CABLE IN (*Not Provided) (*Not Provided) Connect the TV to a wall antenna socket with an RF cable (75 Ω). NOTE yy Use a signal splitter to use more than 2 TVs. yy If the image quality is poor, install a signal amplifier properly to improve the image quality. yy If the image quality is poor with an antenna connected, try to realign the antenna in the correct direction. yy An antenna cable and converter are not supplied.
MAKING CONNECTIONS 19 Connect your TV to external devices. For the best picture and audio quality, connect the external device and the TV with the HDMI cable as shown. Some separate cable is not provided. PCMCIA CARD SLOT MT35*, MT55* DVD / Blu-Ray / PC / HD Cable Box / HD STB AUDIO OUT H/P AUDIO IN (PC) DVI OUT Headphone HDMI OUT (19 V ) COMPONENT IN AV2 IN / AUDIO L R HDMI IN 13/18 V 700mA Max LNB IN 5V 0.5 A 5V 1.
MAKING CONNECTIONS MT75* PCMCIA CARD SLOT ENGLISH DVD / Blu-Ray / PC / HD Cable Box / HD STB HDMI OUT DVI OUT (19 V ) COMPONENT IN AV2 IN / AUDIO L R HDMI IN AUDIO OUT Headphone (Only satellite models) Composite gender cable Component gender cable RED WHITE YELLOW RED WHITE RED BLUE GREEN DVD/ Blu-Ray / HD Cable Box USB / HUB VCR / DVD / Blu-Ray / HD Cable Box Mobile Phone
REMOTE CONTROL 21 The descriptions in this manual are based on the buttons on the remote control. Please read this manual carefully and use the TV correctly. To replace batteries, open the battery cover, replace batteries (1.5 V AAA) matching the and ends to the label inside the compartment, and close the battery cover. To remove the batteries, perform the installation actions in reverse. CAUTION yyDo not mix old and new batteries, as this may damage the remote control.
Using the user guide ENGLISH USIng the user guide OPTION > To set language yyImage shown may differ from your TV. SMART Settings OPTION Language(Language) Selects Menu Language and Audio Language displayed on the screen. SMART button to access the Home menu. 1 Press 2 Select User Guide and press OK . Menu Language Selects a language for the display text.
MAINTENANCE 23 Cleaning Your TV Clean your TV regularly to keep the best performance and to extend the product lifespan. CAUTION yyMake sure to turn the power off and disconnect the power cord and all other cables first. yyWhen the TV is left unattended and unused for a long time, disconnect the power cord from the wall outlet to prevent possible damage from lightning or power surges. Screen, frame, cabinet and stand yyTo remove dust, wipe the surface with a dry and soft cloth.
TROUBLESHOOTING ENGLISH TROUBLESHOOTING Problem Solution Cannot control the TV with the remote control. yyCheck the remote control sensor on the product and try again. yyCheck if there is any obstacle between the product and the remote control. to yyCheck if the batteries are still working and properly installed ( to , No image display and no sound is produced. yyCheck if the product is turned on. yyCheck if the power cord is connected to a wall outlet.
SPECIFICATIONS 25 ENGLISH SPECIFICATIONS Wireless LAN module (TWFM-B006D) specification Standard Frequency Range Output Power (Max.) IEEE 802.11a/b/g/n 2400 to 2483.5 MHz 5150 to 5250 MHz 5725 to 5850 MHz (for Non EU) 802.11a: 11 dBm 802.11b: 14 dBm 802.11g: 10.5 dBm 802.11n - 2.4GHz: 11 dBm 802.11n - 5GHz: 12.5 dBm yy Because band channel used by the country could be different, the user can not change or adjust the operating frequency and this product is set for the regional frequency table.
SPECIFICATIONS Product specifications may be changed without prior notice due to upgrade of product functions. ENGLISH MODELS 24MT35S With stand (mm) Without stand (mm) 556.5 x 343.1 x 62.9 641.2 x 391.3 x 77.6 Weight With stand (kg) 4.0 5.3 3.7 4.7 Without stand (kg) 556.5 x 414.7 x 180.9 27MT55S Dimensions (W x H x D) Power consumption 29 W Power requirement 19 V AC/DC Adapter Manufacturer : APD Model : DA-65G19 MODELS 35 W 3.
SPECIFICATIONS 27 HDMI (DTV) supported mode (Only MT35*) Resolution Horizontal Frequency(kHz) Vertical Frequency(Hz) Resolution Horizontal Frequency(kHz) Vertical Frequency(Hz) 640 x 480 31.469 / 31.50 59.94 / 60.00 640 x 350 31.468 70.09 720 x 480 31.469 / 31.50 59.94 / 60.00 720 x 576 31.25 15.625 50.00 50.00 1280 x 720 37.50 44.96 / 45.00 50.00 59.94 / 60.00 1920 x 1080 33.72 / 33.75 28.125 26.97 / 27.00 33.716 / 33.75 56.25 67.43 / 67.50 59.94 / 60.00 25.00 / 50.00 23.97 / 24.
SPECIFICATIONS ENGLISH NOTE yyAvoid keeping a fixed image on the set’s screen for prolonged periods of time. The fixed image may become permanently imprinted on the screen. Use a screen saver when possible. yyThere may be interference relating to resolution, vertical pattern, contrast or brightness in PC mode. Change the PC mode to another resolution or change the refresh rate to another rate or adjust the brightness and contrast on the menu until the picture is clear.
Make sure to read the Safety Precautions before using the product. Keep the Owner’s Manual (CD) in an accessible place for future reference. The model and serial number of the TV is located on the back and one side of the TV. Record it below should you ever need service.
