User manual

58
ENG
ENGLISH
MAKING CONNECTIONS
y
If the signal is stable and there is no cable loss, in general, up to 25 monitors can be connected via
the DP Out port (at the recommended resolution). If you want to connect more than this number of
monitors, it is recommended to use a distributor.
y
When the Tile Mode is configured via DP, max. 8 monitors can play HDCP-encrypted content.
y
If the signal cable between the product and your PC is too long, make sure to use the Booster or
optical cable.
y
If input signals are received through the DVI/HDMI cable, multiple monitors cannot be connected via
the DP Out port.
NOTE
Daisy Chain Monitors
To use different products connected to each other, connect one end of the signal input cable (DP Cable) to
the DP Out connector of Monitor 1 and connect the other end to the DP In connector of the other product.
Monitor 1 Monitor 2 Monitor 3 Monitor 4
DP Cable
Use the cable provided with the product or use a DisplayPort certified cable version 1.1a or higher.
Using the Multi Display Mode function
The
Multi Display Mode
function displays a video signal received from DP In either in single mode (SST:
Single Stream Transport) or multi-mode (MST: Multi Stream Transport) through DP Out.
- This function can be configured in the
Installation Menu
(For more information, refer to the
Installation Menu manual.)
- If it is
On
, the image of each display is displayed in multi-mode.
- If it is
Off
, the image of each display is displayed in single mode.
- The multi-mode is available in a PC supporting DisplayPort 1.2.
- Multi-mode can connect up to only four monitors. (at the recommended resolution.)
- When this function is used, your monitor may not work properly depending on the video card.
Reboot the PC after setting the function to Off for stable screen output when not in use.