Owners manual

33
Reference
Reference
Controlling a TV with the
Supplied Universal Remote
Control
You can control the volume, input source, and power
state of your TV with the supplied Universal Remote
Control.
If your TV is listed in the table on pages 34-35, set
the appropriate manufacturer code. Follow steps 1-2
as shown right.
You can control your TV using the buttons below.
By pressing You can
TV POWER Turn the TV on or off.
AV Switch the TV’s input source
between the TV and other input
sources.
PR +/– Scan up or down through
memorized channels.
VOL +/– Adjust the volume of the TV.
MUTE Temporarily turns TV sound
OFF, press again to restore.
Note:
Depending on the unit being connected, you may
not be able to control your TV using some of the
buttons.
To programme the remote to control
the TV using the manufacturer code
If your TV is listed in the table on the next page, set
the appropriate manufacturer code.
1. While holding down TV POWER button, press
the number buttons to select the manufacturer
code for your TV (Refer to table on the next
page).
• If more than one code number is listed, try
entering them one at a time until you find the
one that works with your TV.
2. Release TV POWER button.
Notes:
• Depending on your TV, some or all buttons may
not function on the TV, even after entering the
correct manufacturer code.
• If you enter a new code number, the code num-
ber previously entered will be erased.
• When you replace the batteries of the remote,
the code number you have set may be reset to
the default setting. Set the appropriate code
number again.
TV Control
Buttons
TV POWER
Button
Number
Buttons