User guide

4
SAFETY PRECAUTIONS
y
Do not install the product onto a wall
or ceiling that is close to sources of oil
or oil mist.
- The product may be damaged and
fall, resulting in serious injury.
y
Do not place the product where it
might be exposed to dust.
- This may cause fire.
y
Do not use the product in a damp
place, such as a bathroom or a place
exposed to the wind and rain, where
it is likely to get wet.
- This may cause fire or electric
shock.
y
Do not allow a tablecloth or curtain to
block the vents.
- This may cause the internal tem-
perature of the product to rise and
cause fire.
y
When the projector is in use, make
sure that the air inlet (Dust filter)
at the bottom of the product is not
blocked.
y
The distance between the projector
and the wall should be more than
30 cm for ventilation purposes.
- Otherwise, this may cause the inter-
nal temperature of the projector to
rise and cause a fire.
CAUTION
y
When installing the projector on a
table, be careful not to place it near
the edge.
- The projector may fall, causing injury
to persons or damage to the projec-
tor. Make sure that you use a cabinet
or stand that fits the projector.
y
Turn off the projector, disconnect the
power supply, and remove all connec-
tions before moving the projector.
- A damaged cord may cause a fire or
an electric shock.
y
Do not place the product on an un-
stable or vibrating surface such as a
wobbly shelf or a slope.
- It may fall or flip and cause injury.
y
Be careful not to tip or drop the prod-
uct over when connecting external
devices to the product.
- This may cause injury to persons or
damage to the product.
Power
WARNING
y
The grounding wire should be con-
nected.
- Be sure to connect the grounding
wire to avoid damage to the product
or an electric shock when there is a
short circuit.
If it is not possible to ground the unit,
purchase a circuit breaker and con-
nect the product to its wall outlet.
Do not try to ground the product to
the gas pipe, water pipe, lightning
rod, or telephone line, etc.
y
The power plug should be inserted
fully into the power outlet.
- An unstable connection may cause
fire.
y
Do not place heavy objects on the
power cord.
- This may cause fire or electric
shock.
y
Never touch the power plug with a
wet hand.
- This may cause an electric shock.
y
Do not plug too many devices into
one multi-power outlet.
- This may cause fire due to the
power outlet overheating.
y
Remove dust or contaminants around
power plug pins or wall outlets.
- Failure to do so may cause fire.