User guide

Function
25
1. Press the KEYSTONE button on the remote control.
2. Press the ∧, ∨ buttons to select a desired option and press the ＞ button.
3. Press the ∧, ∨, ＜, ＞ buttons to adjust the screen and press OK ◉ .
ꔈ The Keystone is adjusted -100 to 0 or 0 to 100 depending on position.
ꔈ To reset to the factory defaults, perform Picture Reset.
ꔈ You can select this function through the MENU button.
ꔈ Press the BACK button to exit the menu screen.
Using Keystone
* To prevent the screen image from becoming trapezoidal, Keystone adjusts the top and bottom width of the image if the projec-
tor is not set at a right angle to the screen.
* Because the Keystone function may cause inferior screen image quality, use this function only when it is not possible to set up
the projector at an optimal angle.
* You can adjust screen size and focus while installing the projector.
Press the SCREEN SIZE button on the remote control.
Press the TEST PATTERN button on the remote control.
ꔈ You can select this function through the MENU button.
Using the Screen Size Function
Test Pattern Function
ꔈ Settings may vary depending on the input signal.
ꔈ You can also use the MENU or Q.MENU button.
ꔈ Press the BACK button to exit the menu screen.
16:9 OriginalJust Scan
Cinema Zoom1 4:3Zoom
* You can flip the video up/down or left/right.
1. Press the MENU button, then go to Screen with the ∧, ∨, ＜, ＞ buttons and press OK ◉ .
2. Press the ∧, ∨ buttons to go to Projection Mode and press OK ◉ .
ꔈ Select Rear to project an image onto the back of a transparent screen purchased separately.
ꔈ Select Ceiling if you installed the projector on a ceiling.
ꔈ You can select this function through the MENU button.
ꔈ Press the BACK button to exit the menu screen.
Changing Projection Mode
Keystone
Top right
Bottom left
Top left ꔃ
Bottom right
Picture Reset
ꔂ Move ꕉ Prev.
Test Pattern
H 0
V 0
Aspect Ratio
16:9