Full Product Manual
Table Of Contents
- PRODUCT FEATURES
- SAFETY INSTRUCTIONS
- PRODUCT OVERVIEW
- INSTALLATION
- Installation Overview
- Product Specifications
- Installation Location Requirements
- Clearances
- Leveling the Dryer
- Reversing the Door (DLEX4200*, DLGX4201*, DLEX4000*,DLGX4001*, DLE3600*, DLG3601*)
- Reversing the Door (DLEX4500*, DLGX4501*)
- Installing the Side Vent Kit
- Stacking the Dryer
- Venting the Dryer
- Connecting the Inlet Hose (Steam Models)
- Connecting Gas Dryers
- Connecting Electric Dryers
- Final Installation Check
- Installation Test (Duct Check)
- OPERATION
- SMART FUNCTIONS
- MAINTENANCE
- TROUBLESHOOTING
- WARRANTY
16 INSTALLATION
Reversing the Door
(DLEX4500*, DLGX4501*)
WARNING
THE DRYER DOOR IS VERY LARGE AND
HEAVY. Failure to follow the instructions
below can result in damage to the dryer,
property damage or injury to persons.
• To avoid damage to the dryer or the door,
support the door with a stool or box that fits
under the door, or have an assistant support
the weight of the door.
• Always reverse the door BEFORE stacking
the dryer on top of the washer.
• Avoid dropping the door to avoid damage to
the door or the floor.
1
Open the dryer door.
Open Door
2
You will be removing the screws shown below
(6 on left, 4 on right).
3
Remove the four decorative screws on the left
using a screwdriver.
Decorative
Hinge
Screw
4
Remove the two latch screws and the latch.
Latch Screw
CAUTION
Be sure to support the weight of the door
before removing the hinge screws.
5
Hold the hinge in place while removing the
four hinge screws (to prevent the door from
dropping).
Hinge Screw
6
Remove the door from the cabinet cover.
Remove
Door