User's Manual

in turn. If you set the Secret function to the memory address, you will be unable to see the
phone number or to correct it.
Entering Characters
You will be provided with 5types of modes (English Lower, English Upper, Digil, Special Char,
Icon) to enter the characters. Use the upside (é) key to change among the modes while entering
the characters. The present mode is indicated on the lower center of the screen. Whenever you
press the upside (é) key, the modes will change in the order of “ENG” - “eng” - “DIG” -
“SPEC” - “ICON” - “ENG” `````` . Select the mode before you enter the characters, and enter
the characters.
1. When the mode is ready for entry, the cursor (“_“) will be
indicated on the space for entry.
(If you enter one character, the cursor will move to the following
space automatically and wait for entry.)
2. Use the right side (è) key or the “0” key in the “ENG” - “eng” state to place a space among
the characters.
3. Verify if the cursor is placed where the character is to be entered, and change the mode by
using the upside/downside (t / s) key.
4. Verify if the mode requested is indicated on the lower center of the screen, and enter the
character.
5. Use 8 keys of [2]~[9] to enter the character in the “eng” and
“ENG” mode. One key is designated with three or more than
three characters. Therefore, press each key repeatedly for a short
period of time until the character requested appears. For example,
if you want to enter a character “K”, set the “ENG” mode with
the upside/downside (s / t) keys and then press [5] key twice for short time continuously.
6. Enter the numbers of 0~9 with ten keys from [0] to [9] in a “DIG” mode.
(Reference: The “ENG”, “eng” and “DIG” modes remain in the same state even after you
enter a character, while the “SPEC” and “ICON” modes automatically change into an
“ENG” mode after you enter one character.)