FRIDGE-FREEZER User's Guide Please read this User's Guide carefully before operating and keep it handy for reference at all times.
Table of Contents Introduction Installation Operation Suggestion On Food storage Care and Maintenance Trouble Shooting To Reverse the Doors 3 Important Safety Instruction 4 Identification of Parts 6 Location 7 Installation with/without Top Table 7 Adjusting Leveling Screws 8 Starting 9 Temperature Control 9 Defrost 10 Storing food 11 Freezer Compartment 11 Refrigerator Compartment 11 General Information 12 Lamp Replacing 13 Cleaning 13 Trouble Shooting 14 How to Reverse
Introduction Important Safety Instruction This fridge-freezer must be properly installed and located in accordance with the Installation Instruction before it is used. Precaution Never unplug your fridge-freezer by pulling on the power cord. Always grip plug firmly and pull straight out from the outlet. When moving your appliance away from the wall, be careful not to roll over or damage the power cord.
Introduction Important Safety Instruction Danger Risk of child entrapment. Before you throw away your old refrigerator or freezer: Take off the doors. Leave the shelves in place so that children may not easily climb inside. Don't store Don't store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. In the event of an electric short circuit, grounding (earthing) reduces the risk of electric shock by providing an escape wire for the electric current.
Introduction Identification of Parts Eva Door Evaporator Thermostat Control Dial Ice Tray Commodity Racks Drip Tray Egg Tray Shelves (Glass or steel) Magnetic Door Seal Vegetable Drawer Bottle Rack Leveling Screws 6
Installation Location Warning Try not to use the refrigerator for a prolonged time where the temperature drops below 16°C or rises above 32°C. • Avoid placing the refrigerator near any heat sources, direct sunlight or moisture. • Sufficient air circulation is essential for the efficient operation of your refrigerator. • To ensure proper air circulation around the fridge-freezer, please maintain sufficient space on both the sides as well as top and maintain at least 2 inches (5 cm) from the rear wall.
Installation Adjusting Leveling Screws • To avoid vibrations the refrigerator has to be placed on a leveled surface. • If necessary, set the leveling screws to compensate the unevenness of the floor. The front should be slightly higher than the rear so that the door can close more easily. • The Leveling Screws can be adjusted by tilting the refrigerator slightly. • Turning the Leveling Screw clockwise, the refrigerator is raised.
Operation Starting When first turning refrigerator on, allow it to operate for at least 2 to 3 hours to stabilize at normal temperature before loading it with fresh food. If operation is interrupted, allow a 5 minutes delay before restarting. Temperature Control NOTE The DRIP TRAY in the Freezer should be installed exactly to contact with the interior wall. FREEZER CONTROL regulates the temperature in the freezer and is displayed in OFF, 1, 2,...7.
Operation Defrosting 5 1 OFF 7 4 CAUTION 2 3 • It is necessary to regularly defrost your refrigerator in order to ensure efficient operation. The frost on the surface of the evaporator should not exceed 6mm before defrosting. • To defrost, turn the control to ‘OFF’. • Before you start the defrosting operation, remove food from the 6 evaporator, and wrap it with paper or cloth, then put it in a cold place or in another refrigerator. Place the DRIP TRAY in its proper position.
Suggestions on food storage Storing Food • How food is frozen and defrosted is an important factor in maintaining freshness and flavor. • Do not store food which goes bad easily at low temperatures, such as bananas, pineapples and melons. • Allow hot food to cool prior to storing. Adding too much warm food to the refrigerator could spoil other food, and lead to high electric bills. • Do not open doors too frequently.
Care and Maintenance General Information When you plan to be away for an extended period, remove all food, disconnect the power cord, clean the interior thoroughly, and leave the door OPEN to prevent odor formation. Going away Power Failure Most power failures are corrected in an hour or two and will not affect your refrigerator temperatures. However, you should minimize the number of door openings while the power is OFF.
Care and Maintenance Lamp Replacing Unplug the Power Cord from the AC Outlet. w Warning 2 3 4 5 off 1 1. Take the DRIP TRAY and Shelves out to make access easier. 2. Hold the COVER LAMP, Take it out softly from the Thermostat Enclosure with twisting up and down. 3. Turn the lamp counterclockwise, and replace it. 4. Assemble in reverse order of disassembly. Replacement bulb must be the same specification as original.
Trouble Shooting Before calling for service, check this list. It may save you both time and expense. This list includes common occurrences that are not the result of defective workmanship or materials in this appliance. Problem Possible Causes • Power plug may be unplugged from the electric outlet. Plug it in securely. Fridge-Freezer does not operate • House fuse has blown or circuit breaker has tripped. Check and/or replace fuse and reset circuit breaker. • Power cut. Check house lights.
Trouble Shooting Problem Possible Causes • Too frequent or too long door openings. Moisture collects inside • In humid weather, air carries moisture into fridge when doors are opened. • Foods with strong odors should be tightly covered or wrapped. Fridge has odor • Check for spoiled food. • Interior needs cleaning. Refer to CLEANING section. • No power at outlet. Interior light does not work • Light lamp needs replacing. Refer to the Lamp Replacement section.
To Reverse the Doors How to Reverse the Door Your refrigerator is designed with a reversible door, so you may open from either left or right. It is best to reposition the door hinge as necessary at the outset since it is inconvenient to do so later. To change the door hinge please refer to the diagram below and proceed as follows. Precaution 1. Remove all loose fittings from inside the appliance. 2. Carefully lay the appliance on its back on the original packing. 3.
To Reverse the Doors How to Reverse the Door 6. After refit the door, fix the Lower Hinge(L) in the apposite side by using 2xBOLTS. 7. Fix the Leg. 8. Carefully place the appliance in an upright position. Use the Adjustable Foot not to vibrate the appliance, and check that the door opens and closes properly. NOTE In case of applying Reversible door, When you close the door with excessive force, there could be the case that the door doesn’t close because of Reaction force.
P/No.
