6 PRODUCT OVERVIEW PRODUCT OVERVIEW Parts 3 2 4 1 HOOD 2 ICON TOUCH CONTROL PANEL 3 LED STRIP LIGHT 4 MESH FILTER 5 SIDE PANEL (Only for HCED3615S) Specifications Hood Models Hood Width HCED3015S, HCED3615S HCED3015S : 30 Inches HCED3615S : 36 Inches Filters 2 pcs Lights 1(LED Strip type) 1 5
OPERATION 7 1 2 3 4 1 POWER / DELAY OFF BUTTON Power Button Function •• Button will turn power on and off for entire hood (fan and lights). •• Hood will remember the last speed and light level it was turned off at. (Example: Press the button to turn off the hood with fan speed at level 4 and lights on high. Press the again and the hood will turn on with the fan speed set to 4 and the lights on high.) Delay Off Button Function •• With the fan on, press and hold the button for three seconds.
8 SMART FUNCTIONS SMART FUNCTIONS LG SmartThinQ Application The LG SmartThinQ application allows you to communicate with the appliance using a smartphone. Before Using LG SmartThinQ •• For appliances with the 1 or logo Use a smartphone to check the strength of the wireless router (Wi-Fi network) near the appliance. •• If the distance between the appliance and the wireless router is too far, the signal strength becomes weak. It may take a long time to register or installation may fail.
SMART FUNCTIONS •• For appliances with the or logo Settings Allows you to set various options on the hood and in the application. Monitoring Use this function to check the current status from one screen. NOTE •• If you change your wireless router, Internet service provider, or password, delete the registered appliance from the LG SmartThinQ application and register it again. •• This information is current at the time of publication.
10 SMART FUNCTIONS Industry Canada Statement (For transmitter module contained in this product) This device contains licence-exempt transmitter(s)/ receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device.
MAINTENANCE 11 Surface Maintenance Removing Mesh Filters Clean periodically with hot soapy water and a clean cotton cloth. Do not use corrosive or abrasive detergent, or steel wool/scouring pads which will scratch and damage surface. Do not use products containing chlorine bleach or citrus-based cleaners. 1 Push handle on filter toward back of range hood. 2 Pivot the front of the filter down and pull the filter forward to remove it. For heavier soil use liquid degreaser.