Install Manual

AC Module System Installation Manual
Rev. 1.0
Step 2. Find a location for EnerBox2
A. In a house, find out an outlet that is electrically connected to the distribution panel where all of AC modules
are attached.
B. Do not share the outlet with other home appliances like TVs, washing machines, or electronic gadgets, etc.
It will create interference in communication of an EnerBox2 with AC modules.
C. Allow the EnerBox2 to occupy the outlet exclusively.
D. Before connecting the EnerBox2 with the power source, make sure that the gateway / repeater toggle button
is positioned to the G (gateway).
E. Locate the EnerBox2 close to the AC mains and plug on the EnerBox2. When the EnerBox2 starts to operate,
the LED on upper position of the EnerBox2 will be flashing light. Then it will be turned off after the boot
procedure is in completion. Please do not control buttons nor pull the power cord out of an outlet during the
boot procedure.
51
EnerBox2 left-side LEDs and buttons
Distribution
Panel
Copyright © 2017 LG Electronics.
All Rights Reserved.
G/R toggle button
※ When initiate the installed AC module system by turning the circuit breaker on inside the
distribution panel, dummy fault alerts might be found on the web browser or mobile application.
After the AC module system is on operation, the alerts will be disappeared.