Install Manual

AC Module System Installation Manual

Rev. 1.0

5-1 EnerBox2 Inspection

5 Trouble Shooting Guide

If EnerBox2 doesn’t work as guided as in the manual, please follow the steps at first measure before

troubleshooting.

A. Make sure that the power cord is fully engaged into the power outlet and into the EnerBox2 body. If

everything is normal, the LED on upper position of the EnerBox2 will be flashing light then turned off

after the boot procedure is in completion.

B. Check the EnerBox2 operation mode. Enerbox2 usually used as the GATEWAY mode.

C. Reboot the EnerBox2 by pressing the ‘RESET’ pin. If everything is normal. The LEDs will be flashing light

then turned off after the boot procedure is in completion.

D. For another solution, push the ‘FACTORY RESET’ for 3 seconds. The button is placed on the bottom of

the EnerBox2. Four LEDs will be flashing in amber. When it is done, they will be flashing in green. Then,

press the ‘RESET’ button for reboot.

E. Please follow other steps described in this manual. If problems persists, contact LG for technical support.

EnerBox2 left-side

EnerBox2 bottom-side

FACTORY

RESET