Install Manual

AC Module System Installation Manual
Rev. 1.0
80
Copyright © 2017 LG Electronics.
All Rights Reserved.
5-2 Replacing an EnerBox2
First, physically install the new Enerbox2 using the following procedure.
1. Unplug the power cord of the old EnerBox2
2. Place the new EnerBox2 at the same location. Let the new EnerBox2 have a power cord at
then put it into a power outlet (same outlet used by the old EnerBox2).
3. Let the installed EnerBox2 access to internet in reference of AC Module System Installation
Manual where 4-3 installing EnerBox2 describes Step 2.
※ Since you are transferring the information from the Web server to the new EnerBox2, you
need to connect to the Internet to use the ‘Replace’ function.
 Using EnerVu2 website
Go for [ System -> Activated System -> Select the system -> Manage ->
EnerBox Info -> View Detail].
As before, you can find the ‘Replace’ button by pressing EnerBox2 S/N in the left System View
or by clicking ‘View Detail’ in the EnerBox Info.
When you press the ‘Replace’ button, the above popup window will appear. Enter the newly
installed EnerBox2 S/N. Verify it with the ‘Check’ button, and click ‘Replace’ at the bottom
right in order to perform communication between EnerBox2 and the Web server.
※ Replace function should be performed after physical installation in steps 1 ~ 3 above.
If the newly installed EnerBox2 does not connect to the Internet, the Replace function
cannot be executed because the EnerBox2 S/N verification has not been made.