Use and Care Manual

1_MFL67855701_Eng.indd 23 2013.7.24 11:45:21 AM
32
HOW TO USE
ENGLISH
HOW TO USE
Before use
Clean the refrigerator.
Clean your refrigerator thoroughly and wipe o all dust that accumulated during
shipping.
NOTE
Remove adhesive residue by wiping it o with your thumb or dish detergent.
WARNING
Do not scratch the refrigerator with a sharp object or use a detergent that
.
contains alcohol, a ammable liquid or an abrasive when removing any tape
or adhesive from the refrigerator.
Do not peel o the model or serial number label or the technical information
.
on the rear surface of the refrigerator.
Connect the power supply.
Check if the power supply is connected before use.
Read the “Turning On The Power” section.
WARNING
Running the automatic icemaker before connecting it to the water
supply may cause the refrigerator to malfunction.
Turn off the icemaker if the refrigerator is not yet connected to the
water supply.
Turn o the automatic icemaker and then plug the power plug of the refrigerator
into the grounded electric outlet.
* This is applicable only to certain models.
WARNING
Putting food in the refrigerator before it has cooled could cause the
food to spoil, or a bad odor could linger inside the refrigerator.
Wait for the refrigerator to cool.
Allow your refrigerator to run for at least two to three hours before putting food in
it. Check the ow of cold air in the freezer compartment to ensure proper cooling.
The refrigerator makes a loud noise after initial operation.
This is normal. The volume will decrease as the temperature lowers.
Open refrigerator doors and freezer drawers to ventilate the interior.
The inside of the refrigerator may smell like plastic at rst. Remove any adhesive
tape from inside the refrigerator and open the refrigerator doors and the freezer
drawers for ventilation.
ENGLISH

Summary of content (10 pages)