Installation Guide

13INSTALLATION
ENGLISH
Preparing Cabinet Opening
This dishwasher is designed to t a standard
dishwasher opening. An opening may be needed
on both sides to route plumbing and electrical
connections.
24" (610 mm) min.
33 /
8" (854 mm) min.
5
24" (610 mm) min.
1
Select a location as close to the sink as possible
for easy connections to water and drain lines.
2
To ensure proper drainage, install the
dishwasher no more than 12 ft. (3.65 m) from
the sink.
3
If installing the dishwasher in a corner, leave a
minimum of 2" (50 mm) between the dishwasher
and the adjacent wall.
4
To allow for proper clearance of plumbing and
electrical, use the template included with the
literature to determine the clearance on the side
of the cabinet where the cabinet meets the back
wall. Using a 2
1
/2" diameter hole saw, drill a hole
in the target area as shown on the template.
9
4
NOTE
• Do not push.
Removing Lower Cover
1
Remove the two screws attaching the lower
cover to the dishwasher.
2
Remove the lower cover from the base.
3
Remove the insulation pad from behind the
access panel.
CAUTION
• If you lay the dishwasher on its back, do so
carefully to avoid damaging the drain hose and
the tub.
NOTE
• Remember to replace the lower cover when the
installation is complete.
WARNING
• Do not remove safety cover. Removal can result
in re, electric shock or death.