EXCESSIVE WEIGHT HAZARD se the assistance of two or more persons to move or install the refrigerator. Not following these instructions may cause injury fo the back and other parts of the | bed. UNPACKING Before Installing your refrigerator, remove any gaps or temporary snickers.
REFRIGERATOR INSTALLATION DIMENSIONS AND CLEARANCES Check the dimensions of the appliance and the installation path to ensure there is sufficient room to move the refrigerator through doors of narrow openings. If an opening Is too narrow fo fit the refrigerator through, remove the refrigerator doors. Ses How fo Remove and install the Refrigerator Doors in this manual.
REFRIGERATOR INSTALLATION HOW TO REMOVE AND INSTALL THE REFRIGERATOR DOORS {For additional support on this topic, Including helpful videos, please visit us at: wwwig.com}. If entrance is lees than 35 inches wide, the refrigerator's door will need to be removed. IMPORTANT: Before starting, turn off and unplug the refrigerator. Remove all food and the racks from the doors. TOOLS YOU MIGHT NEED OR USE Cops Hex Socket Wrench Phillips Screwdriver No.
REFRIGERATOR INSTALLATION + Yo replace doors, begin with refrigerator road and then follow with freezer door. 4. Replacing Freezer Door « Set the sassafras door onto the Middle Hinge pin (Figure 3. Replacing Refrigerator Door 103. « Place upper hinge In the tap of the freezer doer and » Sat door on Boston Hinge Pin (See Figure 7). line up the hings with the holes in top of refrigerator. + Place hings pin of middle bracket inside the hinge pin Use the three bolts to fasten the hinge {See Figure 11).
REFRIGERATOR INSTALLATION HOW TO REVERSE AND INSTALL THE REFRIGERATOR DOORS {on some models} You may find it more convenient fo have the roads converted from the eff opening type (factory installed) to the right opening type. Directions refer fo the right side as the side on your right as yeu face the unit. Dewar reversal must be done by an authorized Installer or service person. If Tt Is not, the doors wil nat be covered by the warranty.
REFRIGERATOR INSTALLATION 2. Reversing and Reinstalling Refrigerator Door Using a 14" socket wrench, loosen and remove Hinge Pin from the Middle Hinge Bracket. Remove washer under neath the middle hinge and set aside. NOTE: At this point the door will be loose. Slightly lift he door and remove it Using a 3/8" casket wrench with a 2-inch extension and screwdriver, [nose the two bolts and one screw, and waverer the Boston Hinge from right sick of the housing.
REFRIGERATOR INSTALLATION Hinge Pin Bracket Hinge Fin Insert Reverse the Door Closer/Stop by flipping it over. Place i on top of the Hinge Pin insert Bracket, and tighten both down with the screw. Tighten the Hinge Pin Bracket fo the door. NOTE: The Door Closer Stop is only presented on some models. Hinge Pin Bracket Hinge Pin chary \ With a Flathead screwdriver, carefully pry off and remove the cover aver the screw holes on tha left side of refrigerator housing.
REFRIGERATOR INSTALLATION CLOSING THE DOORS AND LEVELING To avoid vibration, the unit must be leveled. If necessary, adjust the leveling legs fo compensate for unevenness of the floor. The front should be slightly higher than the rear fo aid in door closing. The refrigerator has two front leveling legs, ane on the right and one on the left. If your refrigerator seers unstable you would like the doors fo close more easily, simply adjust Tighten Te belts.