Use and Care Manual

23
INSTALLATION AND CA U T I ON
(F OR HEA TI NG FU NCT ION U SE ON LY )
push
Only when you use heating function, draining water is needed. For cooling only function, you do not
need to install this part.
INDOOR DRAINAGE
1.Remove the water plug firstly.
2.Install one end of the pipe to the unit, and put the other end
into a bucket.
CAUTION
When use heating function, it is highly recommended to use Indoor Drainage,because Outdoor Drainage most probablely brings
unexpected troubles.In case Outdoor ,Drainage is not avoidable, please make sure water from the drain mouth of the window kit
will not pollute thewindow-sill or surface of the outside wall ,nor affect anything side of the window.
Do not operate the button on the panel with the glove.
When the outside temperature is below 0℃(32℉) in winter, the drain pipe will freeze if using outside drainage way.In that case ,
you have to use indoor drainage way.
When the relative humidity is 50%,it will generate 800ml water per hour in heating mode.
Please pay attention to select proper bucket, or the water will flow to the floor.
Drainage cover
Drain pipe
Fixing nut
Disassembly
When install the Drain
Pipe must leave 20cm
the window kit.
OUTDOOR DRAINAGE
1.Remove the water plug.
2.Install one end of the pipe to the unit, connect the other
end to the drain hole of the window kit
PUSH
Additional Parts (for heating)
When water is being draining through the drain
pipe,you can press TIMER and DOWN buttons
simultaneously to stop the drain pump inside the
unit running,or press TIMER and DOWN buttons
simultaneously again to let the drain pump
continue to work.
CAUTION