- LG DVD Recorder Owner's Manual

53
Reference
Symptom
Cannot play a disc
recorded using this
recorder on another
player.
Cannot record or did
not record successfully.
Timer recording is not
possible.
Stereo Audio Record
and/or Playback is not
present.
The Remote Control
does not work properly.
Cause
 The disc was recorded in Video mode.
 Some players will not play even a final-
ized disc recorded in Video mode.
 The disc was recorded in VR mode.
 Discs recorded with copy-once material
cannot be played on other players.
 The remaining blank space on the disc
is insufficient.
 The source you are trying to record is
copy protected.
 When setting the recording channel, the
channel is tuned on the TV’s own tuner.
 When recording to a Video mode disc,
programs that are copy-once protected
cannot be recorded.
 Clock in recorder is not set to correct
time.
 Timer has been programmed
incorrectly.
 (Timer record) indicator light does
not appear after programming timer.
 TV is not Stereo-compatible.
 Broadcast program is not in stereo for-
mat.
 The recorder A/V Out jacks are not
connected to TV A/V In jacks.
 The recorder Audio/Video Out is not
selected for viewing at the TV.
 The recorder’s TV audio channel is set
to mono.
 The Remote Control is not pointed at
the remote sensor of the recorder.
 The Remote Control is too far from the
recorder.
 There is an obstacle in the path of the
Remote Control and the recorder.
 The batteries in the Remote Control
are exhausted.
Solution
 Finalize the disc. (page 25)
 No solution.
 The other player must be RW com-
patible in order to play it.
 No solution.
 Use another disc.
 You cannot record the source.
 Select the channel on the recorder’s
built-in TV tuner.
 Use a VR mode formatted disc for
copy-once material.
 Set clock to correct time.
 Reprogram Timer.
 Reprogram Timer.
 No solution.
 No solution.
 Make A/V connections. Stereo is
available only via A/V output from the
recorder.
 Select AUX or A/V source as TV
input.
 Set TV audio channel mode to
Stereo. See [Changing TV audio
channel] on page 27.
 Point the Remote Control at the
remote sensor of the recorder.
 Operate the Remote Control within
7 m.
 Remove the obstacle.
 Replace the batteries with new ones.
Reset the Recorder
If you observe any of the following symptoms...
 When the Recorder is plugged in, but the
power will not turn on or off.
 When the display window does not working.
 When the Recorder does not operate normally.
You can reset the Recorder as follows :
 Press and hold the (POWER) button for
more than five seconds. This will force the
Recorder to power off.
Press the (POWER) button again to turn
the Recorder back on.
 Unplug the power cord and then plug the
power cord again after more than five sec-
onds.