Owners manual

- 8 -
English
Español
SURFACE CONTROLS COOKING
LOCATIONS OF SURFACE
ELEMENTS AND CONTROLS
The surface burner elements are positioned in the same
locations on the cooktop and the control panel for ease of
use.
PF(Power Failure) MESSAGE
The PF message will appear whenever there has been a
power interruption to the appliance. To clear the PF message
touch ON/OFF control pad to reset and be sure to reset the
clock with the correct time of day (see page 17).
HS(Hot Surface) MESSAGE:
• The HS message will appear in the display once the burner
has been turned off and the cooktop is hot to the touch.
(approximately 150 deg F)
-HS will appear during the Self Clean Cycle.
Bridge
Left Rear Element
Bridge
Left Front Element
Triple
Right Front
Triple Element
Warming Zone
Single
Right Rear Element
• The temperature settings can be increased or
decreased by 0.2 increments for setting 1.0
through 3.0 by using the + and - control pad. The
temperature setting can be increased or
decreased by 0.5 for settings 3.0 through 9.0 .
Note: