Installation Guide

16 INSTALLATION
NOTE
depending on the model.
Assembling the Freezer Door
1
Install the freezer door onto the bottom hinge
pin
a
.
2
Fit the hinge
b
over the hinge lever latch
c
and slot it into place. Rotate the lever
d
clockwise and fasten the hinge.
NOTE
the cabinet to help fit
the top hinge in place.
3
Connect all the wire harnesses and the
ground wire.
4
Push the water supply lines into the hole on
the top case and pull them through the
backplate.
NOTE
depending on the model.
5
Hold the water supply connection and gently
push in the collet
e
to connect the water
supply lines as shown. Insert the tube at least
5/8 inch (15 mm) into the connector. Insert
the clip on the joint to fasten the tubes in
place.
NOTE
f
Collet
g
Tube
h
Insert line
i
Clip