Full Product Manual

19INSTALLATION
ENGLISH
CAUTION
• Check to see if leaks occur at the water line
connections.
Route the tubing.
• Route the tubing between the cold water
line and the refrigerator. Route the tubing
through a hole drilled in the wall or oor
(behind the refrigerator or adjacent base
cabinet) as close to the wall as possible.
Connect the tubing to the refrigerator.
Connect the tubing to the valve.
• Place the compression nut and ferrule
(sleeve) for copper tubing onto the end of
the tubing and connect it to the shuto
valve. Make sure the tubing is fully inserted
into the valve. Tighten the compression nut
securely.
Flush out the tubing.
• Turn the main water supply on and ush
out the tubing until the water is clear. Shut
the water o at the water valve after about
one quart of water has been ushed
through the tubing.
Saddle-Type Shuto Valve
Compression Nut
Packing Nut
Outlet Valve
Ferrule (sleeve)
Tubing Clamp
¼ in. Tubing
¼ in. Compression Nut
Ferrule (sleeve)
Refrigerator Connection
6 9
7
8
• Be sure there is sucient extra tubing (about 8
ft. coiled into three turns of about 10 in.
diameter) to allow the refrigerator to move out
from the wall after installation.
• Before making the connection to the
refrigerator, be sure that the refrigerator power
cord is not plugged into the wall outlet.
• Remove the plastic exible cap from the water
valve.
• Place the compression nut and ferrule (sleeve)
onto the end of the tubing as shown.
• Insert the end of the copper tubing into the
connection as far as possible. While holding the
tubing, tighten the tting.
NOTE
NOTE
NOTE
Turn the water on at the shuto valve.
• Tighten any connections that leak.
10