Troubleshooting Guide

51TROUBLESHOOTING
ENGLISH
Water is not
dispensing.
New installation or water line recently connected.
proximately 5 minutes) to remove trapped air
and contaminants from the system. Do not dispense the entire 2.5 gallon amount
continuously. Depress and release the dispenser pad for cycles of 30 seconds ON and 60
seconds OFF.
The dispenser panel is locked.
Lock button for three seconds to unlock the control panel and
dispenser.
The dispenser is not set for water dispensing.
certain that the control panel is set for the
proper operation. Press the Water button on the control panel to dispense water.
Refrigerator or freezer doors are not closed properly.
Water filter has been recently removed or replaced.
5 gallons of water (flush for approximately five
minutes) to remove trapped air and contaminants from the system. Do not dispense the
entire 2.5 gallon amount continuously. Depress and release the dispenser pad for cycles of
30 seconds ON and 60 seconds OFF.
Tubing connecting refrigerator to house supply valve is kinked.
is moved during installation or cleaning.
Resulting in reduced water flow. Straighten or repair the water supply line and arrange it
to prevent future kinks.
The house water supply is not connected, the valve is not turned on fully, or the valve is
clogged.
d turn the water shutoff valve fully open. If
the problem persists, it may be necessary to contact a plumber.
Dispensing warm
water.
Refrigerator was recently installed.
e water storage tank to cool completely.
The water dispenser has been used recently and the storage tank was exhausted.
e water storage capacity will range from
approximately 20 to 30 oz.
Dispenser has not been used for several hours.
ral hours, the first glass dispensed may be
warm. Discard the first 10oz.
Refrigerator is connected to the hot water supply.
WARNING: Connecting the refrigerator to a hot water line may damage the
icemaker.
Problem Possible Cause & Solution