Installation Guide

18 INSTALLATION
WARNING
stances, cut or remove
the third (ground) prong from the power cord.
ve the wall receptacle
and circuit checked by a qualified electrician to
make sure the receptacle is properly grounded.
with a 3-prong (grounding) plug which mates
with a standard 3-prong grounding wall
receptacle to minimize the possibility of electric
shock hazard from this appliance.
encountered, it is the personal responsibility and
obligation of the customer to have it replaced
with a properly grounded three-prong wall
receptacle.
a
exists before use.
plug. Disconnecting of
the power cord places undue strain on the
adapter and leads to eventual failure of the
adapter ground terminal.
with local codes or, in
the absence of local codes, with the National
Fuel Gas Code, ANSI Z223.1/NFPA 54 or, in
Canada, the Natural Gas and Propane
Installation Code, CSA B149.1.
NOTE
gas range receptacles.
devices that sense leakage of current in a
circuit and automatically switch off power
when a threshold leakage level is detected.
These devices must be manually reset by the
consumer. The National Electrical Code
receptacles installed to serve countertop
surfaces.
- Performance of the range will not be affected
if operated on a GFCI-protected circuit but the
occasional resetting of the circuit can become
an annoyance.
Surface Burners
Assembling the Surface Burners
CAUTION
place.
1
Place the burner caps and heads on the
cooktop.
large, one oval(center), and one extra large
burner head and cap.
2
Make sure that the caps and heads are placed
in the correct locations.
3
Make sure the hole in the burner head is
positioned over the electrode.
a
Oval (Center) burner head/cap assembly
b
Medium burner head and cap
c
Small burner head and cap
d
Large burner head and cap
e
Front of range
f
Dual burner head and cap
Extra Large burner head and cap
g
Hole
h
Electrode