Use and Care Manual

54 MAINTENANCE
Grates and burner heads/caps can be removed for
care and cleaning.
CAUTION
properly. They will be stable and rest flat when
correctly installed.
Cleaning Burner Heads/Caps
For even and unhampered flame, the slits in the
burner heads must be kept clean at all times.The
burner heads and caps (and the oval burner head
and cap assembly) can be lifted off. Do not attempt
to remove the oval burner cap.
CAUTION
es with anything hard.
Doing so could damage them.
clean the burners.
rinse with clean water. Run water through the
oval burner from the bottom stem to flush out
debris.
ing the cooktop. The
pointed metal ends on the electrodes could
cause injury. Hitting an electrode with a hard
object may damage it.
in a solution of mild liquid detergent and hot
use a toothbrush or wire brush.
burner ports or electrodes are clogged or dirty.
routinely, especially after excessive spillover.
After Cleaning the Burner Heads/Caps
Shake out any excess water and then let them dry
thoroughly. Placing the oval burner upside down
will allow the water to drain out more easily.
Replace the burner heads and caps over the
electrodes on the cooktop in the correct locations
according to their size. Make sure the hole in the
burner head is positioned over the electrode.
Burner Grates
The range consists of three separate professional-
style grates. For maximum stability, these grates
should only be used when in their proper position.
The center grate can be interchanged from front
to back.
a
Side grate
b
Center grate
CAUTION
for an extended period
of time without cookware on the grate. The
finish on the grate may chip without cookware to
absorb the heat.