REFRIGERATOR INSTALLATION CLOSING AND ALIGNING THE DOORS Tos avoid vibration, tha unit must be leveled. If necessary, adjust the Leveling Lags fo compensate for unevenness of the floor. The front should be slightly higher than the rear to aid in door closing. Your refrigerator has three front leveling screws, one on the right and one on the left.
ENSURING PROPER AIR CIRCULATION in order fo obtain stable temperature, the air must flow tween the freezer and refrigerator sections. As shown in the illustration below, the cold air enters through the bot torn part and circulates upward, This air returns below the freezer floor and the rest of the alr enters the refrigerator section through the fop vent, Be not block any of Hess vents with packages of food. This can interrupt the flow of alr and cause temperature and moisture problems.
ADJUSTING CONTROL SETTINGS Give th refrigerator ims to cos! down completely before adding ford. It is best te wait 24 hours before adding fond fo the refrigerator. The mid-settings indicated In the previous section should be correct for normal household refrigerator usage. The controls are set correctly when milk or juice is cold fo your liking and ice cream is firm, The refrigerator control functions as the thermostat for the entire appliance.
Packaging Recommendations: < Use sealed plastic containers. = Use plastic containers with a smooth surface. « Package with aluminum foil of high resistance. © Wrap with paper layered with plastic. « Use water proof plastic. « Use calendared plastic bags fo store frozen foods. Follow these packaging or container instructions in order to reach the best freezing Bo not usa: + Bread Wrapping. + Plastic container not safe for storing. = Containers without lids or seals. < Waxed paper or waxed plastic.
Grasp the drawer handle and pull it forward fo the drawer stop. Lift up and pull out. To replace ths Pantry Drawer: Slide the drawer back all the way past the drawer spat. ice Tray {On some models) » Pour potable water fo the level indicated in the picture. De nat overfill with water or lee cubes will be difficult fo remove « For quick frazzles, adjust the freezer dial to 3. Tinnitus the ice tray to remove the ice cubes + Do net bend the ice fray. Doing s5 may result In damage to the tray.
USING YOUR REFRIGERATOR WATER DISPENSER {On some medals) To dispense cold water, push on the dispenser switch with a glass. Sims dripping may occur after dispensing. Hold your cup beneath the dispenser for a faw seconds after dispersing fo catch all of the drops. FR WARNING: Do not put your fingers up the ice chute spanning. Doing so can result in severs injury. PR CAUTION: Do not dispense ice info fine china or Crystal glasses. China or crystal can break.
WATER FILTER WATER FILTER {On some models) it is recommended that you replace the water filter. «Approximately every 6 morphs. © When the Filter Rehangs Indicator turns on, When the water dispenser output decreases, When the ice cubes are smaller than normal. . REMOVE THE OLD WATER FILTER. NOTE: Ra placing the water fitter causes & small amount of water {around drain, Wrap » cloth around the front and of the water filter cover to collect any water.
REFRIGERATOR CARE AND CLEANING EXPLOSION HAZARD Do not use flammable cleaners. Not following these instructions can cause death, explosion or fire. The refrigerator, as well as the freezer, do their own DE-freszing. This process does not prevent the build up of contaminants, therefore if Is suggested that you clean both parts once a month; clean spilled liquids immediately. REFRIGERATOR CLEANING « Unplug your refrigerator. = Pull out all of the removable parts (such as the vegetable and dairy doors).
REFRIGERATOR CARE AND CLEANING WHEN MOVING If you decide to take your refrigerator with you when roving, consider the following: 1. Remove all of the food from if, and place the frozen food in an ics chest with dry ice. 2.Unplug your refrigerator. 3. Ernpty the water from ifs tray. 4, Clean and dey It with a rag. 5.Pull out ali of the removable pairs, and wrap them with adhesive tape. 6.
NOTE: It is necessary to have a water source when goth water and/or ice dispensers ars available in your product, Check the specifications and model of your refrigerator. BEFORE START The water source Is not guaranteed by the refrigerator manufacturer. Fellow instructions carefully in order fo reduce damage. Air located inside the water pips can cause hammering or tapping causing damage to the inner pipes or water spillage In the inside of the refrigerator.
CONNECTING THE WATER LINE 3. DRILL A HOLE FOR THE VALVE Drill a 1/4" {6,35 rm) diameter heel in the water pipeline. Remove Jagged edges produces after perforation. Make sure water does not reach the drill Not performing the 1/4" (6,35 mm} perforation can lead fo a low or smaller ice production. 4. TIGHTEN THE VALVE Tight the valve into the cold water pipeline with a tube trap.