an tle eto \ Use this page fo become more familiar with the pairs and features of your refrigerator. Page references are included for your convenience. NOTE: This guide covers several models. The refrigerator you have purchased may have same or all of the items fist ad below. Tha locations of the features shown below may not match your model.
EXCESSIVE WEIGHT HAZARD Use the assistance of two or more persons te move or install the refrigerator. Not following these instructions may cause injury to the back and other parts of the [Ye UNPACKING Before installing your refrigerator, remove any tape or temporary stickers. Do not remove any stickers that feature warnings, the model serial number ar the technical label of the product located an the back of the refrigerator.
REFRIGERATOR INSTALLATION HOW TO REMOVE AND INSTALL THE REFRIGERATOR DOORS {For additional support on this topic, including helpful videos, please visit us at: wall. corm). if insurance is Isis than 35 inches wide, the refrigerator's doer will need fo be removed, IMPORTANT: Before starting, turn off and unplug ths refrigerator. Remove all ford and the racks from ths doors. TOOLS YOU MIGHT NEED OR USE 1 Un Eee men \ Hex Socket Wrench Phillips Screwdriver No.
REFRIGERATOR INSTALLATION » To replace doors, begin with refrigerator door and then follow with freezer door. 4. Replacing Freezer Door « Sat the freezer door ante the Middle Hinge pin {Figure 3. Replacing Refrigerator Door 0). « Place upper hinge in the fop of the freezer door and + Sat door on Bottom Hinge Pin {See Figures 7). line up the hinge with the holes in top of refrigerator. + Place hinge pin of middle bracket inside the hinge pin Use the three bolts Jo fasten the hinge {Ses Figure Ti).
REFRIGERATOR INSTALLATION HOW TO REVERSE AND INSTALL THE REFRIGERATOR DOORS (on some models) You may find it more convenient fo have the doors converted from the left opening type {factory installed) fo the right opening type. Directions refer to the right side as the side on your right as you face the unit. REVERSIBLE DOORS MODELS TOOLS YOU MIGHT NEED OR USE LTCS20220° LTCS24223" LTNS20220° 1d PRESBYTER —% vn GT58BP" RT LTWS24223% $ Tammi fence a) LTCSs06a0" Hex Socket Wrench Phillips Screwdriver No.
deacon nie og els 2. Reversing snd Reinstalling Refrigerator Door Using a %" socket wrench, Enos and remove Hings Pins from tha Middle Hinge Racks? Remove washer underneaths the middle hinge and sat asides. NOTE: At this point the door will ba loose, Slightly if the door and remove it. Using a 3/8" socket wrench with a 2-Inch extension and screwdriver, loosen the two bolts and ene screw, and remove the Bottom Hinge from right side of the housing.
REFRIGERATOR INSTALLATION Flip the Middle Hinge Bracket, (flange will now be an top} position if on left side of the refrigerator and reattach with two boils and a Phillips screwdriver. Place the refrigerator door down over the pin on the bottom hinge. Hinge Place the washer between the refrigerator door and Pin Bracket middle hinge and reattach Hinge Pin fo Hinge Bracket with a %* socket wrench.