Installation Guide

12
INSTALLATION
Cabinet Installation
1
Open the window. Mark a line on the center
of the inside sill and extending across the
center of the outside sill.
Loosely attach each sill bracket to a support
bracket using a carriage bolt and a lock nut.
Sill Bracket
Carriage
Bolt
Lock Nut
Support Bracket
2
Carefully place the cabinet in the window
and align the center hole on the cabinet
bottom front with the center line marked on
the window sills. Align the support brackets
with the cabinet track holes and mark the
sill along the sides of each sill bracket.
Remove the cabinet from the window and
attach each sill bracket on the outside sill
between the marks using 2 type B screws.
Sill
Bracket
3
Carefully place the cabinet back in the
window and align the cabinet track holes
with the support brackets. Attach each
support bracket to the cabinet through a
cabinet track hole, using a type D screw
and a lock nut. Use the rst track hole past
the sill bracket on the outer edge of the
window sill. Tighten the lock nuts on the
support brackets to secure them to the sill
brackets. Be sure the cabinet slants down
toward the outside.
Support Bracket
Lock
Nut
4
Insert the lower curtain panel guides into
the bottom of the cabinet. Insert the guides
so that the ange faces to the rear of the
cabinet.
5
Upper Panel Guide
Right Curtain Panel
Left Curtain Panel
Lower Panel
Guide
Insert the top and bottom rails of the curtain
panels into the upper and lower panel
guides.
CAUTION
●The lower panel guides are easily broken.
Be careful with them when installing the
cabinet.
6
Fasten the curtain panels to the unit with 10
type A screws.