Measurement Guide

LWD3063*
QUICK INSTALL &
CLEARANCES
For full installation directions/clearances
please refer to the corresponding
User Manual and Installation Guide.
DIMENSIONS & WEIGHT
Product 29-3/4"(W) x 52-1/16"(H) x 24-3/8"(D)
Cut-out 28- 1/2"(W) x 51-15/16"(H) x 23-1/2"(D)
Packing 33"(W) x 30"(D) x 57"(H)
Net weight (Kg) Approx. 122.6 kg (270lbs)
Gross weight(Kg) Approx. 137.6 kg (303bs)
POWER/RATINGS
Rating 7.8 KW
Electric supply 120/240 VAC,120/208 VAC
Max. Amp Load 32.5 A
The rst step of the installation
is measure the current cutout
dimensions and compare them
to the cutout dimensions
shown below. Little or no
cabinet work may be necessary.
CUTOUT DIMENSIONS
•
Cabinet Width
30” (762 mm)
•
Recommended Minimum
Cutout Location from Floor
12” (304.8 mm)
•
Cutout Depth
23-1/2” Min. (596.9 mm)
•
Cutout Width
28-1/2” Min. (723.9 mm)
28-5/8” Max. (727 mm)
•
Cutout Height
51=13/16” Min. (1316 mm)
51-15/16” Max. (1319.2 mm)
IMPORTANT NOTES
•
The cabinet base platform must be able to support 325lbs (147kg). If
the cabinet does not have a solid bottom, two braces or runners must
be installed level with the bottom of the cutout to support the weight
of the oven. Make sure the base is level and the front of the cabinet is
square. If the cabinet base is not level, the oven glides will tend to slide
out when opening the door.
•
If marks, blemishes or the cutout opening are visible above the installed
oven, it may be necessary to add wood shims under the runners and
front trim until the marks or opening are covered.
•
If the cabinet does not have a front frame and the sides are less than
3/4” (1.9 cm) thick, shim both sides equally to establish the cutout
width.
•
The junction box must be ush with the rear wall of the cabinet as
shown below.
•
Allow at least a 23” clearance for the door depth when it is open.
•
Kitchen cabinets in contact with the oven must be heat resistant up to
194°F (90°C), and fronts of nearby units up to at least 158°F (70°C).
PRODUCT DIMENSIONS
27 3/8”
(69.5 cm)
52 1/16”
(132.2 cm)
29 3/4”
(75.5 cm)
23 3/8”
(59.3 cm)
51 5/8”
(131.0 cm)
Junction Box
Location
47”
30”
23”
5”
28 1/2” Min.
28 5/8” Max.
51 13/16” Min.
51 15/16” Max.
Allow 1”
minimum for
overlap of oven
Allow 1”
minimum for
overlap of oven
23 1/2”
Minimum cutout location from floor 12”
27 3/8”
(69.5 cm)
52 1/16”
(132.2 cm)
29 3/4”
(75.5 cm)
23 3/8”
(59.3 cm)
51 5/8”
(131.0 cm)
Junction Box
Location
47”
30”
23”
5”
28 1/2” Min.
28 5/8” Max.
51 13/16” Min.
51 15/16” Max.
Allow 1”
minimum for
overlap of oven
Allow 1”
minimum for
overlap of oven
23 1/2”
Minimum cutout location from floor 12”
LG Brand_Wall Ovens Fin_1.indd 2 8/21/17 4:08 PM