ENGLISH ITALIANO ESPAÑOL FRANÇAIS DEUTSCH OWNER’S MANUAL AIR CONDITIONER Please read this manual carefully before operating your set and retain it for future reference. TYPE : MULTI The equipment complies with requirements of the Technical Regulation, in terms of restrictions for the use of certain dangerous substances in electrical and electronic equipment. www.lg.
Multi Type Air Conditioner Ownerʼs Manual TABLE OF CONTENTS Safety Precautions.........................3 FOR YOUR RECORDS Write the model and serial numbers here: Operating Instructions...................6 Model # Serial # Care and maintenance.................24 You can find them on a label on the side of each unit. Dealer's Name Before you call for service... .......26 Date Purchased n Staple your receipt to this page in the event you need it to prove date of purchase or for warranty issues.
Safety Precautions To prevent injury to the user or other people and property damage, the following instructions must be followed. n Incorrect operation due to ignoring instruction will cause harm or damage. The seriousness is classified by the following indications. This symbol indicates the possibility of death or serious injury. This symbol indicates the possibility of injury or damage to properties only. n Meanings of symbols used in this manual are as shown below. Be sure not to do.
Safety Precautions n Operation Do not let the air conditioner run for a long time when the humidity is very high and a door or a window is left open. • Moisture may condense and wet or damage furniture. Take care to ensure that power cable could not be pulled out or damaged during operation. Do not place anything on the power cable. • There is risk of fire or electric shock. • There is risk of fire or electric shock. Do not touch(operate) the product with wet hands.
Safety Precautions Always check for gas (refrigerant) leakage after installation or repair of product. • Low refrigerant levels may cause failure of product. Do not install the product where the noise or hot air from the outdoor unit could damage the neighborhoods. • It may cause a problem for your neighbors. Install the drain hose to ensure that water is drained away properly. • A bad connection may cause water leakage. Use two or more people to lift and transport the product. • Avoid personal injury.
Operating Instructions Operating Instructions Name and Function of Remote Controller Duct Type Remote Controller AUTO SWING OPERATION SET TEMP Room Temp Timer Operation unit 03 AUTO Heater Preheat JET Defrost Humidify Filter Out door ZONE 1 2 3 4 1 Program set 05 07 09 11 13 3 Signal Receiver 7 8 9 10 11 12 SUB FUNCTION HI MED LO Time On Off Set no. Time 01 FAN SPEED 15 17 19 21 23 2 Timer Cancel Program Week 5 6 4 Holiday Plasma 14 SET/CLR Hour Min 13 1.
Operating Instructions ENGLISH Name and Function of Remote Controller('06 Model) AUTO SWING OPERATION SET TEMP Room Temp 2ndF Timer FAN SPEED SUB FUNCTION HI MED LO AUTO Heater Preheat JET Defrost Humidify SLo Filter Out door ZONE 1 2 3 4 Time Operation unit No Func Program set On Off Set no. Time 01 03 05 07 09 11 13 15 17 19 21 23 3 Signal receptor 8 9 10 11 12 13 14 1 2 Timer Program Cancel Week 5 2ndF 6 Holiday PLASMA Set/Clr Hour Min 1.
Operating Instructions Optional Function • WIRELESS REMOTE CONTROLLER This air-conditioner is equipped with wired remote controller basically. But if you want to have the wireless remote controller, you pay for it. 1. FAN Operation Button Used to circulate room air without cooling or heating. 2. Cooling Operation Button Signal transmitter Transmits the signals to the signal receptor. 3. Soft Dry Operation Button Used to dehumidify without overcooling. 4.
Operating Instructions • WIRELESS REMOTE CONTROLLER This air-conditioner is equipped with wired remote controller basically. But if you want to have the wireless remote controller, you pay for it. Signal transmitter 1. OPERATION MODEL SELECTION BUTTON Used to select the operation mode Transmits the signals to the signal receptor. 2. FAN SPEED BUTTON Used to set the desired fan speed. 3. ROOM TEMPERATUR BUTTON Used to set desired horizontal airflow direction. 4.
Operating Instructions Set the Current Time and a day of the Week 1 Press the ' ' button. Hour Each time the button is pressed, the number is changed from 00 to 23. You can set the number of the current hour. AUTO SWING OPERATION SET TEMP Room Temp AUTO Heater Preheat JET Defrost Humidify Filter Out door ZONE 1 2 3 4 Time Timer Operation unit 2 Press the ' 03 SUB FUNCTION HI MED LO Hour On Off Set no. Time 01 FAN SPEED Program set 05 07 09 11 13 15 17 19 21 23 ' button.
Operating Instructions 1 ENGLISH Weekly Programming Press the Program button. The remote controller is displayed like a picture. Then ' Program ', ' Program set AUTO SWING OPERATION ' and '01' is blinked. SET TEMP Room Temp 2 Week Press the ' Press Week 03 SUB FUNCTION HI MED LO AUTO Heater Preheat JET Defrost Humidify Filter Out door ZONE 1 2 3 4 Time Operation unit Timer On Off Set no. Time 01 FAN SPEED Program set 05 07 09 11 13 15 17 19 21 23 ' button.
Operating Instructions Holiday Setting If Tuesday is a holiday in this week, you may set a holiday. Program 1.Press the Program button. Week 2. Press the Week button. Select the Tuesday. 3. Press the Holiday button. Holiday AUTO SWING OPERATION SET TEMP Room Temp Then the remote controller will be displayed ' The outside rectangular means holiday. 4. Press the Program button again to finish holiday setting. Timer Operation unit On Off Set no.
Operating Instructions ENGLISH Operation Mode Cooling Mode Cooling Mode Soft Dry Mode Soft Dry Mode Heating Mode Auto Mode (Cooling Model) Auto Mode (Heat Pump Model) Operation Procedure 1st On/Off Button AUTO SWING OPERATION SET TEMP Room Temp 2ndF Timer 2nd SUB FUNCTION HI MED LO AUTO Heater Preheat JET Defrost Humidify SLo Filter Out door ZONE 1 2 3 4 Time Operation unit No Func Program set On Off Set no.
Operating Instructions Cooling Operation Mode 1 Press the On/Off Button. 2 Select Cooling Operation. Press the Operation Mode Selection Button. Each time the button is pressed, the operation mode is shifted in the arrow direction.
Operating Instructions ENGLISH Soft Dry Operation Mode This mode dehumidifies without overcooling. 1 2 Press the On/Off Button. Select Soft Dry Operation. Press the operation Mode Selection Button. Each time the button is pressed, the operation mode is shifted in the arrow direction.
Operating Instructions Heating Operation Mode (Heat pump model only) 1 2 Press the On/Off Button. Select Heating Operation. Press the Operation Mode Selection Button. Each time the button is pressed, the operation mode is shifted in the arrow direction.
Operating Instructions ENGLISH Auto Operation Mode 1 Press the On/Off Button. 2 To select Auto Operation, press the Operation Mode Selection button. Each time the button is pressed, the operation mode is shifted in the direction of the arrow.
Operating Instructions FAN Operation 1 Press the On/Off Button. 2 Press FAN Operation Button. 3 Each time Indoor Fan Speed button is pressed, the fan speed mode is shifted in the arrow direction. AUTO SWING OPERATION SET TEMP FAN SPEED Room Temp AUTO Heater Preheat JET Defrost Humidify Filter Out door ZONE 1 2 3 4 Time Timer Operation unit 03 AUTO SWING OPERATION 05 07 09 11 13 SET TEMP 15 03 AUTO SWING OPERATION 23 SUB FUNCTION • Fan speed is low.
Operating Instructions 1 Press the On/Off Button. 2 Select heating+ E/heater Operation. ENGLISH Electric Heater Operation Mode(Optional) Press the Operation Mode Selection Button. Press the Heater Operation Button on the remote controller.(When the unit operates in heating mode.) AUTO SWING OPERATION SET TEMP FAN SPEED Room Temp AUTO Heater Preheat JET Defrost Humidify Filter Out door ZONE 1 2 3 4 Time Timer Operation unit On Off Set no.
Operating Instructions PLASMA Purification Operation (Optional) 1 AUTO SWING OPERATION SET TEMP Room Temp 2ndF Timer FAN SPEED SUB FUNCTION 2 HI MED LO AUTO Heater Preheat JET Defrost Humidify SLo Filter Out door ZONE 1 2 3 4 Time Open the door on the remote control. Press the PLASMA On/OFF button. Operation will start when the button is pressed and stop when the button is pressed again. Plasma Operation unit No Func Program set On Off Set no.
Operating Instructions Calling from outside, you can start the air conditioner to keep the room comfortable. Even though you went out with the air conditioner on, you can turn it off using the phone outside. TURN ON 1. Dial the number which is connected with the air conditioner. 2. After ringing 5 times. 3. You can hear the "Beep" sound (if the air conditioner is off), then press "0" "0" "7" "8" accordingly. ON OFF 4. With the sound "Beep, Beep" the air conditioner starts on. 5. Hang up the phone.
Operating Instructions Telephone Control Operation(When using along with ARS telephone) Calling from outside, you can start the air conditioner to keep the room comfortable. Even though you went out with the air conditioner on, you can turn it off using the phone outside. TURN ON 1. Dial the number which is connected with the air conditioner. 2. OGM guide is provided after signal sound rings four times and then "Beep"(sounds from telephone itself) sounds so that outside recording can be done.
Operating Instructions ENGLISH Operation Details • Cooling Operation Mode When the room temperature is higher than the set temperature, it operates in cooling mode at the set temperature, the set fan speed, and then it will be in automatically turn off when the room temperature reaches the set temperature +0.5°C. ROOM TEMP. More 3 minutes OPERATION START SET TEMP. +0.5°C) OPERATION STOP SET TEMP. -0.
Care and maintenance Care and maintenance Caution: Before performing any maintenance, turn off the main power to the system. Indoor Unit Grille, Case, and Remote Control o Turn the system off before cleaning. To clean, wipe with a soft, dry cloth. Do not use bleach or abrasives. Note: Supply power must be disconnected before cleaning the indoor unit. o Never use any of the followings: • Water hotter than 40°C Could cause deformation and/or discoloration.
Care and maintenance When air conditioner is not going to be used for a long time. 1. Operate the air conditioner on Air circulation mode for 2 to 3 hours. • This will dry out the internal parts. 2. Turn off the circuit breaker. CAUTION Turn off the circuit breaker when the air conditioner is not going to be used for a long time. Dirt may collect and may cause a fire. When the air conditioner is to be used again. • Check that the air inlet and outlet of the indoor/outdoor unit are not blocked.
Before you call for service... Before you call for service... Troubleshooting Tips! Save time and money! Check the following points before requesting repairs or service.... If the malfunction persist, please contact your dealer. Case Explanation See page The air conditioner does not operate. • Have you made a mistake in timer operation? • On first starting, the indoor unit operates in fifteen seconds.
