Owners manual

6 Multi Type Air Conditioner
Operating Instructions
Operating Instructions
h Display temperature can be different from actual room temperature if the remote controller is
installed at the place where sun-rays are falling directly or the place nearby heat source.
Plasma
Signal Receiver
RESET
Timer Cancel
Program Week Holiday
SET/CLR
MinHour
Humidify
AUTO
AUTO SWING
JET
OPERATION FAN SPEED
Program set
SUB FUNCTION SET TEMP
Room Temp
HI
MED
LO
Heater
Defrost
Filter
Preheat
Out door
Timer
On
Set no. Time
Off
01 03 05 07 09 11 13 15 17 19 21 23
Time
Operation unit
3
7
8
9
10
11
12
13
2
1
5
4
6
15
14
ZONE
1234
Duct Type Remote Controller
1. Operation display
Displays the operation conditions.
2. On/Off Button
Operation starts when this button is
pressed, and stops when the button is
pressed again.
3. Set Temperature Button
Used to set the temperature when the
desired temperature is obtained.
4. FAN Operation Button
Used to circulate room air without
cooling or heating.
5. Fan Speed Button
Used to set desired fan speed.
6. Operation Mode Selection Button
Used to select the operation mode.
• Auto Operation Mode.
• Cooling Operation Mode.
• Soft Dry Operation Mode.
• Heating Operation Mode.(except
cooling model)
7. Timer Cancel Button
Used to cancel the timer.
8. Timer Set Button
Used to set the timer when the desired
time is obtained.
9. Week Button
Used to set a day of the week.
10. Program Button
Used to set the weekly timer.
11. Holiday Button
Used to set a holiday of the week.
12. Time Set Button
Used to set the time of the day and
change the time in the weekly timer
Function.
13. Set and Clear Button
Used to set and clear the weekly timer.
14. Room Temperature Checking Button
Used to check the room temperature.
15. Reset Button
Used to set the current time and clear
the setting time.
Name and Function of Remote Controller