Installation Guide

1.Disconnect the microwave oven before proceeding with the installation.
2.Fasten the anti-tip bracket to the bottom duct by using four round-head screws.
3.Remove any loose items inside the microwave oven,including the turntable
and turntable support.Carefully turn the microwave upside down.
4.Install bottom duct with four round-head screws as shown.
3.INSTALL THE ANTI-TIP BRACKET AND BOTTOM DUCT (FIG 3)
2.INSTALL THE ANTI-TIP BRACE
(FIG 2)
FOR INSTALLATION ABOVE A BUILT-IN OVEN
1.DIMENSIONS OF THE INSTALLATION OPENING (FIG 1)
The following opening dimensions in feet must be available in the
installation cabinet :
HEIGHT :
16
3
⁄
WIDTH :
1
4. ,
25 ⁄
1
2. ,
DEPTH :
19 ⁄2. or 22.
(FIG 2)
1.Draw a line on the cutout floor at the center of the cutout, and extend the line
1/2 ″ down the face of
the cabinet.
2.Draw a line on the top front face of the cabinet at the center of the cutout. The
line should extend 1/2″ up the face of the cabinet. This center line will be used
for mounting the top bracket (see step 7).
3.Fold or cut the front edge of the template, along the front guide line. Place
the template flush along the front edge of the cutout floor, aligning the center
line of the template with the center line of the cutout floor. Mark the center
positions with an awl or center punch for the anti-tip brace location as shown.
Depth
Height
1
1
⁄4″ Overlap
Width
1
1
⁄8″ Overlap
1″ Clearance
beyond trim frame
(on all sides)
3″ Min.
27″ Models:
11
⁄16″ overlap
30″
Models: 2
1
⁄16″ overlap
Bottom of trim kit
must be minimum
of 36 ″from floor
D
D
Round-head
screws
(2)
Round-Head Screws
Microwave Oven Upside Down
Anti-Tip Brace
Front
Re
ar
Round-Head
Screws (4)
DIMENSIONS:
A = 1
1
⁄2″
B = 3″
C = 18
3
⁄16″
D = 1/2″
FIG 1
FIG 2
FIG 3
WARNING: This trim kit uses air flow
from the top, bottom and sides of the trim frame.
Blocking the air flow can cause the microwave to
function improperly and
may cause damage to
the microwave.
Allow a 1 clearance beyond the edge of the trim frame to provide proper air flow.
On 27 models, allow 1
1
/8 at the top,
11
16
/
on the sides
and 1
1
/4 at the bottom for
overlap of the Trim Frame over the edges of the cutout.On 30″models, allow
at the top, 2
1
/16″ on the sides
and at the bottom for overlap of the
Trim Frame
over the edges of the cutout.
Microwave oven should be installed on a 3/8″ plywood base and support
by 2x4 or 1x2 equivalent runnerson all sides. Base must be capable of
supporting aminimum of 100 lbs (45.3 kg).
″
″
″
″
2
″
″
″
″
1
1
/4
″
1
1
/8
″