Installation Guide
Table Of Contents
4.INSTALL SIDE DUCT AND UPPER DUCT
(
FIG 4)
5.
INSTALL MICROWAVE OVEN INTO CABINET (FIG 5)
6.CHECK LEVELING (FIG 6)
Ensure that
Top Bracket
is Level
Align Center
Lines on
Cabinet and
Top Bracket
Mark Screw
Hole Locations
(also on left
side of
bracket)
Round-Head
Screws
Cutout
Opening
Existing Screw (1)
(2)
(1)
Upper Duct
Side Duct
3 Tabs
2.Set the microwave upright, being careful not to bend the front flange. Remove the one
existing screw from the left side of the microwave oven.
3.As indicated on the supplied template, fold or cut along the “cut lines” and place the
template on top of the microwave oven. By aligning the template with the outside edges
of the oven, you will see exactly where to place the upper duct assembly. Peel off the
backing from the double-sided tape. Carefully position the side duct and upper duct
assembly on the microwave cabinet, aligning with the bottom screw hole. Press down
firmly on the ducts. Fasten the duct assembly to the left side of the cabinet with the
screw removed above.
1.Connect the side duct to the upper duct as shown.
(1 ) Insert projecting tabs of the upper duct into the holes of the side duct.
(2) Bend the tabs up with caution as shown.
NOTE: Remove any oil or dirt on the surface of the microwave oven before the
ducts are attached.
FIG 4
1.Slide the microwave oven part way into the cabinet opening.
2.Plug in the microwave oven.
3.The anti-tip bracket must be flat to the cutout floor to engage cor
rectly with the
anti-tip brace as shown. Carefully slide the mic
rowave back, making sure the
power cord is not mashed or
cut.
4.Center the microwave oven within the cutout opening and slide the microwave
oven in place, engaging the anti-tip brace.
5.Ensure the microwave oven is accurately centered.
.
FIG 5
1.Check the leveling by placing a level
at the front and sides of the
mic
rowave.
It may be necessary to add
wood shims under the bottom
duct
to level the
microwave front to back
or side to side.
FIG 6
Anti-Tip Assembly
Bottom
Duct
Round-Head
Screw
Anti-Tip Bracket
Anti-Tip
Brace
3