Installation Guide

7.
INSTALL THE TOP BRACKET (FIG 7)
Ensure that
Top Bracket
is Level
Align Center
Lines on
Cabinet and
Top Bracket
Mark Screw
Hole Locations
(also on left
side of
bracket)
Round-Head
Screws
Cutout
Opening
Round-Head
Sc
rews
Cutout
Opening
Positioning
Flange
Flat -Head
Screws
Flat -Head Screws
Ensure that
Top Bracket
is
Level
Align Center
Line
s on
Cabine
t and
Top Bracket
Mark Screw
Hol
e Locations
(also
on left
side
of
brac
ket)
1.Place the top bracket flange on top of the upper duct with the opening
of the top
bracket lined up with the opening on the upper
duct.
2.Align the center line marking on the top bracket with the center
line drawn on the
top front face of the cabinet at the center
of the cutout.
3.Ensure the top bracket is level and mark screw hole locations on
the cabinet face.
4.Drill pilot holes through the side holes in the top bracket. Secu
re the top bracket to
the cabinet using four round-head sc
rews (see illustration in step 8).
8.
INSTALL THE BOTTOM BRACKET AND SECURE THE
TOP BRACKET (FIG 8)
1.Drill pilot holes through the three holes on the front flange of the bottom
duct assembly.
2.Hold the bottom bracket against the front flange of the bottom duct assembly,
lining up the three holes in the bottom bracket with the three holes in the bottom
duct. Screw in three round-head screws. Drill pilot holes through the four holes
in the tabs on the sides of the bottom bracket. Screw in four round-head screws.
9.
INSTALL THE TRIM FRAME (FIG 9)
Place the trim frame over the microwave oven with the
curved edge at the top.
Press the trim frame into the opening until all sides snap
into place.
Open
the microwave oven door. Secure the trim frame using
four flat-head screws (two on the inside top and two on the
inside bottom).
1.Place the trim frame over the microwave oven with the curved edge at the top..
2.Press the trim frame into the opening until all sides snap into place.
3.Open the microwave oven door. .Secure the trim frame using four flat-head screws
(two on the inside top and two on the inside bottom).
10.REPLACE ANY LOOSE ITEMS
1.Your trim kit is now fully installed. Replace the turntable and turntable
support that
were removed from the inside of
the microwave oven.
2.Keep these installation instructions and extra screws for future reference and need.
Do not place them in the mic
rowave oven.
3.Replace house fuse or close circuit breaker.
FIG 7
FIG 8
FIG 9
4
Flat -Head Screws