Installation Guide

9INSTALLATION
ENGLISH
Step 3: Prepare the Venting Blower
Your microwave oven is shipped with the blower
assembled for room venting. You need to adjust
the blower if you want wall-venting or roof-venting
installation.
WARNING
• Electric shock hazard! Unplug unit before
working on it.
• Do not pull or stretch the blower wiring. Pulling
and stretching the blower wiring could result in
electric shock.
• To avoid risk of property damage, unplug the
microwave oven or disconnect the power at the
source by removing the fuse or throwing the
circuit breaker.
• To avoid risk of personal injury, wear protective
gloves when handling the mounting plate.
Installation
1 Remove any shipping materials and parts
from inside the microwave oven. Set them
aside for later use.
2 Cover the countertop or cooktop with a thick,
protective covering to protect it from damage
and dirt.
a Blanket, cardboard or other covering
NOTE
• If you have a free-standing range, disconnect it,
move it onto a piece of cardboard or hardboard
and pull it away from the wall, so that you can
get closer to the upper cabinet and back wall for
easier measuring and drilling.
3 Locate the exhaust adapter, grease filters and
hardware packet.
4 At this point, remove any adhesive tape (if
there is any), on the exhaust adapter, the
grease filters and the power supply cord.
Room-Venting (Recirculating)
Installation
This oven is shipped assembled for room-venting.
Wall-Venting Installation
1 Remove one or several blower plate mounting
screw(s) a and one or two blower unit
mounting screw(s) f. Remove the blower
plate
d from the cabinet.
b Blower unit
c Knockouts
e Back plate
2 Carefully lift the blower unit out of the
microwave oven.
For 3 1/4" x 10" systems
1/4" x 10" 90° elbow
a (1ea)
Wall cap
b(1ea)
Straight duct (8 ft)
Total length
= 25 ft
= 40 ft
= 8 ft
= 73 ft
For 6" round systems
Transition (1ea)
90°elbows
b (2ea)
Wall cap
c (1ea)
Straight duct (8 ft)
Total length
= 5 ft
= 20 ft
= 40 ft
= 8 ft
= 73 ft
6 ft
2 ft
2 ft
6 ft
us_main.book.book Page 9 Wednesday, May 4, 2022 1:09 PM