User manual

PAGE 47
Programming the Remote
Test your remote control.
To find out whether your remote control can
operate the device without programming,
turn on the device such as a the VCR and
press the corresponding MODE button (VCR)
on the remote control while pointing at the
device. Test the POWER and CH +/- buttons
to see if the device responds properly. If
not, the remote requires programming to
operate the device.
Turn on the device to be programmed. Then
press the corresponding MODE button on
the remote control.
Press the MENU button and the MUTE but-
ton simultaneously. Now the remote control
is ready to program the code for the corre-
sponding device.
There are two ways to find the right code for
the device.
A. If you press the CH +/- buttons repeat-
edly, the codes will change one at a time.
Press the POWER button after each code
change. If the right code is found, the
device will turn off.
B. Enter a code number using the number
buttons on the remote. The right code num-
bers for the corresponding component can
be found on the following pages.
Again, if the code is correct, the device will
turn off when you press the POWER button.
Press the MENU button to store the code.
Test the remote control functions to see if
the device responds properly. If not, repeat
from step 2.
1
2
3
4
5
6
The remote control is a multi-brand or universal
remote control that can be programmed to oper-
ate most remote-controllable devices of other
manufacturers.
Note: The remote control may not be able to con-
trol all models of other brands.
LIG
HT
TV/VID
EO
MODE
FRONT
MUTE
SURF
VOL CH
RATIO
CC
AVL
SLEEP
MENU
VIDEO AUDIO
EXIT
PLAY PAUSE STOP RECORD
PIP PIP ch- PIP ch+ PIPinput
FREEZE
ENTER
SAP SWAP
REW FF SKIP
COMP/DVI
FLASHBK ENTER
POWER
2
4
4
3
3/5
4