User's Manual

Terminal Development Center
8
LGIC
6. Convenient Functions [ Menu + 6 ]
* Area code input/setup, automatic reception, calculator, voice recognition setup, automatic
answer functions can be set.
6.1 Automatic Area Code
* The stored area code is added to the dial number automatically while a call is originated.
l Select Menu + 6 + 1.
l Select one of ‘Setup/Release’ using the next setup key (Soft Key1) or ‘V/#’ key and press
STORE key.
l If you select ‘Release’, it will be in the stand-by state. In case there is a pre-stored number, that
number will be deleted.
l Press SETUP to enter the area code. [Max. up to 4 digits ]
l Press OK key to store the entered contents.
If the entered area code is not registered one, a message of ‘Wrong Number’ appears with a
beep alarm and it returns to its initial stage.
¢Ã World Area Code (Skip)
6.2 Automatic Reception
* If the user does not answer an incoming call, after the telephone rings as many times as the set
number of the bell for the automatic reception, call is established automatically.
l Select Menu + 6 + 3
l Select one of ‘Release / After 1st Ring / After 3rd Ring’ using the next setup key (Soft Key1) or
‘V/#’ key and press STORE key.
In case of melody, the incoming call is received after the 1
st
tune regardless of the setting
value.
6.3 Calculator
* [Add / Subtract / Multiply / Divide] can be executed.
* You can enter the decimal point with [ V ] key.
l Select Menu + 6 + 4.
l Enter numbers. [9 digits can be entered including the decimal point]
l Select operators using Soft Key1 key.
l Enter numbers. [9 digits can be entered including the decimal point]