User's Manual

Terminal Development Center
6
LGIC
locking on the [Select] key is released and the [Locking Release] button is changed to [Select]
button.
- Even in this case, whenever you try to call, the password is required.
- If you want the locking release, you should release this setup from the [Menu].
l If you select ‘Power-On’, the locking function is not immediately executed but when the phone is
switched on, it is automatically set to the lock mode and at the same time, the soft key is changed
to [Menu], [Locking Release].
Default password is ‘0000’.
5.2. Call List Delete
* Function to delete all the telephone numbers stored in the last call list.
l Select Menu + 5 + Password 4-digit + 2
l Select ‘Yes’ from Yes/No using the next setup key (Soft Key1) or ‘V/#’ key and press the
SELECT key.
5.3. Private Information Delete
* Function to delete all the contents stored in the memory address 01 ~ 200.
l Select Menu + 5 + Password 4-digit + 3.
l Select ‘Yes’ from Yes/No using the next setup key (Soft Key1) or ‘V/#’ key and press the
SELECT key.
During the deletion, a message of ‘Please, wait’ appears and after the completion of the deletion
it returns to the stand-by status.
5.4 Voice List Delete
* Function to delete all the voice items (20 entities) from the memory addresses where voice is
stored of memory address 01 ~ 200.
l Select Menu +5+ Password 4-digit + 4.
l Select ‘Yes’ from Yes/No using the next setup key (Soft Key1) or ‘V/#’ key and press the
STORE key.
5.5. Emergency Phone Number Store
* Function used to enter the emergency telephone number [Up to 3 numbers ]
l Select Menu + 5 + Password 4-digit + 5.
If the telephone number stored in the telephone number 1is appeared empty, a message of