BZ03 Cassette Player / Receiver with 4-Channel High Power Output Flip Down Detachable Face Panel & ISO DIN Mounting Chassis Owner's Manual TCC-9510
CAUTION Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. To avoid electrical shock; do not open the cabinet. Refer servicing to qualified personnel.Shock hazard-do not open. CAUTION TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK) NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
1. VIOLET 2. VIOLET / BLACK STRIPE 3. GRAY 4. GRAY / BLACK STRIPE 5. WHITE 6. WHITE / BLACK STRIPE 7. GREEN 8. GREEN / BLACK STRIPE WIRING CONNECTIONS 10A 3 Note Make correct connections as illustrated in the connection diagram. Never use the cord of each speaker in common. Precaution on making connections Before connecting, make sure that ignition switch is set to OFF, and remove the terminal of the battery to avoid short circuits.
LOUD SPEAKER 1. + R i g h t R e a r 2. - R i g h t R e a r 3. + R i g h t F r o n t 4. - R i g h t F r o n t 2 - Speaker Connections : : : : VIOLET VIOLET/BLACK GRAY GRAY/BLACK 4 5. + L e f t 6. - L e f t 7. + L e f t 8.
Insert the holder into the car radio slot. Fasten the holder by pulling and bending the tabs which are located around the holder as illustrated. HOLDER 5 Insert the enclosed handles into the slits of the unit, as illustrated, while pressing the handle lightly, then pull the unit out of the holder. Press the open knob to open up the front panel and detach it by pulling it towards you. Use only the supplied mounting hardware for safe and secure installation.
1. Press the open knob to open up the panel. 2. Holding the middle upper side of the panel, pull it straight out towards the arrow direction.(See the figure) 3. The red lamp blinks to tell you that the front panel has been detached.(It could be stolen) : Option 4. Keep the front panel in the supplied protection case. Detaching the front panel FRONT PANEL 6 If it works malfunction, take the panel off and put it back again.
1. POWER ON/ OFF(PWR) 2. VOLUME UP / DOWN 3. BAND 4. AUDIO SELECTOR 5. EQ 6. MODE 7 7. DIR/MUTE 8. LCD 9. INTRO SCAN(INT) 10. REPEAT(RPT) 11. PRESET STATION 12. SUPER-BASS/LOC FUNCTION DESCRIPTION, CONTROLS 13. AUT(AUTO TRAVEL PRESET) 14. TUNE(AUTO / MANUAL) 15. TUNING & TRACK UP / DOWN (TUN 16. SCAN 17. DISPLAY (DSP) 18.
) ) ) Pressing the audio select button, you can adjust BASS, TREBLE, BALANCE, FADER and VOLUME. Select the item you want to adjust by pressing the audio selector repeatedly. Adjust the selected item within 5 seconds. (After 5 seconds the function will again serve as the volume control.) 3. AUDIO SELECTOR (SEL, Rotate outer SEL button clockwise/counterclockwise to increase/decrease the VOLUME, BASS, TREBLE, BALANCE, FADER, depending on what you select using the audio selector. 2.
) ) Press this button to mute the sound temporarily. To cancel the mute mode, press this button again. 9. MUTE ( ) LOCAL STATION (LOC, ) When pressed this button for more than 1.5seconds, it displays the message “LOC”. This is used to change the tuning stop level during search. The LOCAL mode is established when the button is pressed to its ON position. At this position, stations with weak transmissions signals are skipped.
, ) Rewind Fast-forward During playback, rotate the Tune button clockwise / counterclockwise to rewind/ fast forward. To start playback during fast forwarding, press the DIR button again. Fast winding the tape ( Open the front panel by pressing the open ( ) button. Insert a cassette tape. Close the front panel. Play will start automatically. If a tape is already inserted, press the DIR button. Listening to a tape CASSETTE PLAYER 10 Open the front panel by pressing “OPEN” ( ).
) ) ) Press this button briefly you can change the side of the tape that is playing. Press this button more than 2 seconds, to mute the sound temporarily. To cancel the mode press again. 16. DIR (DIR, If you want to listen to a song repeatedly, press the RPT button, then “RPT” appears on the display. This function will operate right after the song which you are listening. Press the button once again, the function returns to normal play mode. 15.
DIR, ) ) ) Press the Repeat button to play the same track continuously. Press the Repeat button more than 2 seconds to play the same CD continuously. 3. REPEAT FUNCTION (RPT, Press the INT button to know what songs are on the CD during playback, then it starts to play the first 10 seconds of the tracks which are from the next song to the last one, while the “INT” appears on the display.
Frequency Range Stereo separation Signal to Noise ratio Frequency step (Manual) TUNER SECTION FM 87.5-108MHz 30dB 55dB 50KHz OIRT 65-74MHz 30dB 55dB 10KHz 50dB 9KHz 13 MW 522-1620KHz 0.35% 50dB 35dB 63Hz-10kHz( 3dB) 4.75cm/sec 178 50 152.5( 1.4 Kg The working life of this product is 7 years since the date of purchase. NOTE ! Designs and specifications are subject to change without notice for improvement.
P/N:3828R-F016Y